77 lines
2.3 KiB
Plaintext
77 lines
2.3 KiB
Plaintext
# Copyright (c) 2019 Alexander Wachter
|
|
# SPDX-License-Identifier: Apache-2.0
|
|
|
|
config NET_L2_CANBUS
|
|
bool "Enable CANBUS L2 layer [EXPERIMENTAL]"
|
|
depends on CAN_NET
|
|
select NET_6LO
|
|
help
|
|
Add a CANBUS L2 layer driver. This is the layer for IPv6 over CAN
|
|
(6loCAN). It uses IPHC to compress the IP header and ISO-TP for
|
|
flow control and reassembling.
|
|
|
|
if NET_L2_CANBUS
|
|
|
|
config NET_L2_CANBUS_USE_FIXED_ADDR
|
|
bool "Use fixed L2 address"
|
|
help
|
|
Use a fixed L2 address for 6LoCAN instead of a random chosen one.
|
|
|
|
config NET_L2_CANBUS_FIXED_ADDR
|
|
hex "L2 address"
|
|
depends on NET_L2_CANBUS_USE_FIXED_ADDR
|
|
range 0x00FF 0x3DEF
|
|
|
|
config NET_L2_CANBUS_DAD_RETRIES
|
|
int "Number of DAD retries"
|
|
default 5
|
|
help
|
|
Number of retries for Duplicate Address Detection.
|
|
Greater than one only makes sense for random link layer addresses.
|
|
|
|
config NET_L2_CANBUS_STMIN
|
|
int "STmin"
|
|
default 0
|
|
range 0 127
|
|
help
|
|
Minimal separation time between frames in ms.
|
|
The timer starts when the frame is queued and the next frame is
|
|
transmitted after expiration.
|
|
STmin is chosen by the receiver and transmitted in the FC
|
|
(Flow Control) frame. See also: ISO 15765-2:2016
|
|
|
|
config NET_L2_CANBUS_BS
|
|
int "BS (Block Size)"
|
|
default 8
|
|
range 0 256
|
|
help
|
|
Number of CF (Contiguous Frame) PDUs before next FC (Flow Control)
|
|
frame is sent. Zero value means all frames are sent consecutive
|
|
without an additional FC frame.
|
|
A BS counter at the sender counts from one to BS. When BS is reached,
|
|
the sender waits for a FC frame again an BS is reset.
|
|
See also: ISO 15765-2:2016
|
|
|
|
config NET_L2_CANBUS_ETH_TRANSLATOR
|
|
bool "Enable 6LoCAN to Ethernet translator"
|
|
depends on NET_L2_ETHERNET
|
|
help
|
|
Enable a 6LoCAN Ethernet translator. With this translator it is
|
|
possible to connect a 6LoCAN network to a Ethernet network directly,
|
|
via a Switch or trough a router. Messages that goes through the
|
|
translator have a special address and the MAC address is carried inline.
|
|
The packet is forwarded with uncompressed IPv6 header.
|
|
|
|
module = NET_L2_CANBUS
|
|
module-dep = NET_LOG
|
|
module-str = Log level for CANbus L2 layer
|
|
module-help = Enables CANbus L2 to output debug messages.
|
|
source "subsys/net/Kconfig.template.log_config.net"
|
|
|
|
endif # NET_L2_CANBUS
|
|
|
|
config NET_L2_CANBUS_RAW
|
|
bool "Enable CANBUS RAW l2 layer"
|
|
help
|
|
Add a CANBUS L2 layer driver. This is the layer for SOCKET CAN.
|