146 lines
3.7 KiB
C
146 lines
3.7 KiB
C
/*
|
|
* Copyright (c) 2018 Foundries.io Ltd
|
|
*
|
|
* SPDX-License-Identifier: Apache-2.0
|
|
*/
|
|
|
|
#define DT_DRV_COMPAT openisa_rv32m1_lptmr
|
|
|
|
#include <zephyr.h>
|
|
#include <sys/util.h>
|
|
#include <drivers/timer/system_timer.h>
|
|
#include <soc.h>
|
|
|
|
/*
|
|
* This is just a getting started point.
|
|
*
|
|
* Assumptions and limitations:
|
|
*
|
|
* - system clock based on an LPTMR instance, clocked by SIRC output
|
|
* SIRCDIV3, prescaler divide-by-1, SIRC at 8MHz
|
|
* - no tickless
|
|
*/
|
|
|
|
#define CYCLES_PER_SEC sys_clock_hw_cycles_per_sec()
|
|
#define CYCLES_PER_TICK (CYCLES_PER_SEC / CONFIG_SYS_CLOCK_TICKS_PER_SEC)
|
|
|
|
/*
|
|
* As a simplifying assumption, we only support a clock ticking at the
|
|
* SIRC reset rate of 8MHz.
|
|
*/
|
|
#if defined(CONFIG_TIMER_READS_ITS_FREQUENCY_AT_RUNTIME) || \
|
|
(MHZ(8) != CONFIG_SYS_CLOCK_HW_CYCLES_PER_SEC)
|
|
#error "system timer misconfiguration; unsupported clock rate"
|
|
#endif
|
|
|
|
#define SYSTEM_TIMER_INSTANCE \
|
|
((LPTMR_Type *)(DT_INST_REG_ADDR(0)))
|
|
|
|
#define SIRC_RANGE_8MHZ SCG_SIRCCFG_RANGE(1)
|
|
#define SIRCDIV3_DIVIDE_BY_1 1
|
|
#define PCS_SOURCE_SIRCDIV3 0
|
|
|
|
struct device; /* forward declaration; type is not used. */
|
|
|
|
static volatile uint32_t cycle_count;
|
|
|
|
static void lptmr_irq_handler(struct device *unused)
|
|
{
|
|
ARG_UNUSED(unused);
|
|
|
|
SYSTEM_TIMER_INSTANCE->CSR |= LPTMR_CSR_TCF(1); /* Rearm timer. */
|
|
cycle_count += CYCLES_PER_TICK; /* Track cycles. */
|
|
z_clock_announce(1); /* Poke the scheduler. */
|
|
}
|
|
|
|
int z_clock_driver_init(struct device *unused)
|
|
{
|
|
uint32_t csr, psr, sircdiv; /* LPTMR registers */
|
|
|
|
ARG_UNUSED(unused);
|
|
IRQ_CONNECT(DT_INST_IRQN(0),
|
|
0, lptmr_irq_handler, NULL, 0);
|
|
|
|
if ((SCG->SIRCCSR & SCG_SIRCCSR_SIRCEN_MASK) == SCG_SIRCCSR_SIRCEN(0)) {
|
|
/*
|
|
* SIRC is on by default, so something else turned it off.
|
|
*
|
|
* This is incompatible with this driver, which is SIRC-based.
|
|
*/
|
|
return -ENODEV;
|
|
}
|
|
|
|
/* Disable the timer and clear any pending IRQ. */
|
|
csr = SYSTEM_TIMER_INSTANCE->CSR;
|
|
csr &= ~LPTMR_CSR_TEN(0);
|
|
csr |= LPTMR_CSR_TFC(1);
|
|
SYSTEM_TIMER_INSTANCE->CSR = csr;
|
|
|
|
/*
|
|
* Set up the timer clock source and configure the timer.
|
|
*/
|
|
|
|
/*
|
|
* SIRCDIV3 is the SIRC divider for LPTMR (SoC dependent).
|
|
* Pass it directly through without any divider.
|
|
*/
|
|
sircdiv = SCG->SIRCDIV;
|
|
sircdiv &= ~SCG_SIRCDIV_SIRCDIV3_MASK;
|
|
sircdiv |= SCG_SIRCDIV_SIRCDIV3(SIRCDIV3_DIVIDE_BY_1);
|
|
SCG->SIRCDIV = sircdiv;
|
|
/*
|
|
* TMS = 0: time counter mode, not pulse counter
|
|
* TCF = 0: reset counter register on reaching compare value
|
|
* TDRE = 0: disable DMA request
|
|
*/
|
|
csr &= ~(LPTMR_CSR_TMS(1) | LPTMR_CSR_TFC(1) | LPTMR_CSR_TDRE(1));
|
|
/*
|
|
* TIE = 1: enable interrupt
|
|
*/
|
|
csr |= LPTMR_CSR_TIE(1);
|
|
SYSTEM_TIMER_INSTANCE->CSR = csr;
|
|
/*
|
|
* PCS = 0: clock source is SIRCDIV3 (SoC dependent)
|
|
* PBYP = 1: bypass the prescaler
|
|
*/
|
|
psr = SYSTEM_TIMER_INSTANCE->PSR;
|
|
psr &= ~LPTMR_PSR_PCS_MASK;
|
|
psr |= (LPTMR_PSR_PBYP(1) | LPTMR_PSR_PCS(PCS_SOURCE_SIRCDIV3));
|
|
SYSTEM_TIMER_INSTANCE->PSR = psr;
|
|
|
|
/*
|
|
* Set compare register to the proper tick count. The check
|
|
* here makes sure SIRC is left at its default reset value to
|
|
* make the defconfig setting work properly.
|
|
*
|
|
* TODO: be smarter to meet arbitrary Kconfig settings.
|
|
*/
|
|
if ((SCG->SIRCCFG & SCG_SIRCCFG_RANGE_MASK) != SIRC_RANGE_8MHZ) {
|
|
return -EINVAL;
|
|
}
|
|
SYSTEM_TIMER_INSTANCE->CMR = CYCLES_PER_TICK;
|
|
|
|
/*
|
|
* Enable interrupts and the timer. There's no need to clear the
|
|
* TFC bit in the csr variable, as it's already clear.
|
|
*/
|
|
irq_enable(DT_INST_IRQN(0));
|
|
csr = SYSTEM_TIMER_INSTANCE->CSR;
|
|
csr |= LPTMR_CSR_TEN(1);
|
|
SYSTEM_TIMER_INSTANCE->CSR = csr;
|
|
return 0;
|
|
}
|
|
|
|
uint32_t z_timer_cycle_get_32(void)
|
|
{
|
|
return cycle_count + SYSTEM_TIMER_INSTANCE->CNR;
|
|
}
|
|
|
|
/*
|
|
* Since we're not tickless, this is identically zero.
|
|
*/
|
|
uint32_t z_clock_elapsed(void)
|
|
{
|
|
return 0;
|
|
}
|