/**
@page UTILS_ReadDeviceInfo UTILS example
@verbatim
******************** (C) COPYRIGHT 2017 STMicroelectronics *******************
* @file Examples_LL/UTILS/UTILS_ReadDeviceInfo/readme.txt
* @author MCD Application Team
* @brief Description of the UTILS example.
******************************************************************************
* @attention
*
* Copyright (c) 2017 STMicroelectronics.
* All rights reserved.
*
* This software is licensed under terms that can be found in the LICENSE file
* in the root directory of this software component.
* If no LICENSE file comes with this software, it is provided AS-IS.
*
******************************************************************************
@endverbatim
@par Example Description
This example describes how to read UID, Device ID and Revision ID and save
them into a global information buffer.
Then UID, Device ID and Revision ID will be saved in following global variables:
- aShowDeviceID: Device identifier
- aShowRevisionID: Revision identifier (This field indicates the revision of the device.
For example, it is read as 0x1000 for Revision 1.0)
- aShowCoordinate: X and Y coordinates on the wafer expressed in BCD format
- aShowWaferNumber: WAF_NUM[7:0], Wafer number (8-bit unsigned number)
- aShowLotNumber: LOT_NUM[55:0], Lot number (ASCII encoded)
@par Keywords
System, Utils, Device info, UID, Device ID, Revision ID, Wafer, Lot number,
@par Directory contents
- UTILS/UTILS_ReadDeviceInfo/Inc/stm32f4xx_it.h Interrupt handlers header file
- UTILS/UTILS_ReadDeviceInfo/Inc/main.h Header for main.c module
- UTILS/UTILS_ReadDeviceInfo/Src/stm32f4xx_it.c Interrupt handlers
- UTILS/UTILS_ReadDeviceInfo/Src/main.c Main program
- UTILS/UTILS_ReadDeviceInfo/Src/system_stm32f4xx.c STM32F4xx system source file
@par Hardware and Software environment
- This example runs on STM32F411xx devices.
- This example has been tested with NUCLEO-F411RE board and can be
easily tailored to any other supported device and development board.
@par How to use it ?
In order to make the program work, you must do the following :
- Open your preferred toolchain
- Rebuild all files and load your image into target memory
- Run the example
*/
3d6be4bd40