In current code, on uefi platform, vmcs will be overwritten according to
uefi context, using the exec_vmwrite directly.
This patch use vmx_write_cr<#> interface to init control registers.
Signed-off-by: Binbin Wu <binbin.wu@intel.com>
Acked-by: Eddie Dong <eddie.dong@intel.com>
- Ajust the order of control registers just for more clear in logic.
Will not change the guest init state after the ajustment.
- Add a comment to point out the CR4 should be inited before CR0.
The value of CR4 will be used during CR0 set.
Signed-off-by: Binbin Wu <binbin.wu@intel.com>
Acked-by: Eddie Dong <eddie.dong@intel.com>
To handle cpu down/up dynamically, arcn needs to support vmx off/on
dynamically. Following changes is introduced:
vmx_off will be used when down AP. It does:
- vmclear the mapped vcpu
- off vmx.
exec_vmxon_instr is updated to handle start and up AP both. It does
- if vmx was on on AP, load the vmxon_region saved. Otherwise,
allocate vmxon_region.
- if there is mapped vcpu, vmptrld mapped vcpu.
Signed-off-by: Zheng Gen <gen.zheng@intel.com>
Signed-off-by: Yin Fegnwei <fengwei.yin@intel.com>
Acked-by: Eddie Dong <Eddie.dong@intel.com>
Enable VMX vpid ctrl and assign an unique vpid to each vcpu
so that VMX transitions are not required to invalidate any
linear mappings or combined mappings.
SDM Vol 3 - 28.3.3.3
If EPT is in use, the logical processor associates all mappings
it creates with the value of bits 51:12 of current EPTP.
If a VMM uses different EPTP values for different guests, it may
use the same VPID for those guests. Doing so cannot result in one
guest using translations that pertain to the other.
In our UOS, the trusty world and normal world are using different
EPTP. So we can use the same VPID for it.
Signed-off-by: Li, Fei1 <fei1.li@intel.com>
Acked-by: Eddie Dong <eddie.dong@intel.com>
In current code, sos/uos bsp can only start from 64bit mode.
For sbl platform:
This patch start sos bsp from protected mode by default.
CONFIG_START_VM0_BSP_64BIT is defined to allow start sos bsp
from 64bit mode. If a config CONFIG_START_VM0_BSP_64BIT
defined in config file, then sos bsp will start from 64bit mode.
This patch start uos bsp from real mode, which needs the integration
of virtual bootloader (vsbl).
For uefi platform:
This patch sets sos bsp vcpu mode according to the uefi context.
This patch starts uos bsp from protected mode, because vsbl is not ready
to publish for uefi platform yet. After vsbl is ready, can change to
start uos bsp from real mode.
Signed-off-by: Binbin Wu <binbin.wu@intel.com>
Reviewed-by: Eddie Dong <eddie.dong@intel.com>
Reviewed-by: Kevin Tian <kevin.tian@intel.com>
Acked-by: Xu, Anthony <anthony.xu@intel.com>
In current implementation, a vcpu can only start from real mode
or 64bit mode.
This patch adds support to start a vcpu from protected mode.
Signed-off-by: Binbin Wu <binbin.wu@intel.com>
Reviewed-by: Eddie Dong <eddie.dong@intel.com>
Reviewed-by: Kevin Tian <kevin.tian@intel.com>
Acked-by: Xu, Anthony <anthony.xu@intel.com>
In current implemenation, cr0/cr4 host mask value are set
according to the value from fixed0/fixed1 values of cr0/cr4.
In fact, host mask can be set to the bits, which need to be trapped.
This patch, add code to support exiting long mode in CR0 write handling.
Add some check when modify CR0/CR4.
- CR0_PG, CR0_PE, CR0_WP, CR0_NE are trapped for CR0.
PG, PE are trapped to track vcpu mode switch.
WP is trapped for info of protection when paing walk.
NE is always on bit.
- CR4_PSE, CR4_PAE, CR4_VMXE are trapped for CR4.
PSE, PAE are trapped to track paging mode.
VMXE is always on bit.
- Reserved bits and always off bits are not allow to be set by guest.
If guest try to set these bits when vmexit, a #GP will be injected.
Signed-off-by: Binbin Wu <binbin.wu@intel.com>
Reviewed-by: Kevin Tian <kevin.tian@intel.com>
Reviewed-by: Jason Chen CJ <jason.cj.chen@intel.com>
Acked-by: Xu, Anthony <anthony.xu@intel.com>
Guest CR3 read/write operations are not trapped.
Remove CR3 handling in cr_access_vmexit_handler.
Also remove unused API vmx_read_cr3.
Signed-off-by: Binbin Wu <binbin.wu@intel.com>
Reviewed-by: Kevin Tian <kevin.tian@intel.com>
Move from vmexit.c to vmx.c
Declare the functions in vmx.h
Rename the functions' name with prefix vmx_.
Signed-off-by: Binbin Wu <binbin.wu@intel.com>
Reviewed-by: Kevin Tian <kevin.tian@intel.com>
Don't panic system when execute vmxon instruction failed.
And let's follow that only print error info when error return
from library function.
Signed-off-by: Li, Fei1 <fei1.li@intel.com>
Reviewed-by: Kevin Tian <kevin.tian@intel.com>
According to the comments in hypervisor:
" This file includes config header file "bsp_cfg.h" and other
hypervisor used header files.
It should be included in all the source files."
this patch includes all common header files in hypervisor.h
then removes other redundant inclusions
Signed-off-by: Zide Chen <zide.chen@intel.com>
Now one uint64_t type is used to obtain the corresponding descriptor_table
for GDT/IDT. This will cause the stack protect corruption under -O2.
So the descriptor_table struct is added to configure the GDT/IDT of VMCS.
V1->V2: Move the descriptor_table into vmx.h header file
And its type is renamed from dt_addr_t to descriptor_table.
Signed-off-by: Zhao Yakui <yakui.zhao@intel.com>
Signed-off-by: Zheng Gen <gen.zheng@intel.com>
Reviewed-by: Jason Chen CJ <jason.cj.chen@intel.com>
Acked-by: Anthony Xu <anthony.xu@intel.com>
Acked-by: Eddie Dong <eddie.dong@intel.com>
The RFLAGS will be touched in some inline assembly.(exec_vmxon/
RFLAGS_RESTORE). The "cc" constraint should be added. Otherwise
it won't be handled under -O2 option.
And "%%XXX" register should also be added into constraints.
Otherwise it will be optimized incorrectly.
Signed-off-by: Zhao Yakui <yakui.zhao@intel.com>
Signed-off-by: Zheng Gen <gen.zheng@intel.com>
Reviewed-by: Jason Chen CJ <jason.cj.chen@intel.com>
Acked-by: Anthony Xu <anthony.xu@intel.com>
Acked-by: Eddie Dong <eddie.dong@intel.com>
before just AP can run "rdtscp" intruction, if run it on BSP,
it will cause "illegal instruction"; now align BSP & AP.
also remove duplicated code.
Signed-off-by: Minggui Cao <minggui.cao@intel.com>
Acked-by: Anthony Xu <anthony.xu@intel.com>
Update X86_FEATURE_OSXSAVE when enabled and replace is_xsave_supported
with cpu_has_cap(X86_FEATURE_OSXSAVE).
Signed-off-by: Li, Fei1 <fei1.li@intel.com>
Acked-by: Eddie Dong <eddie.dong@intel.com>
This is workaround patch to resolve Disti performance issue.
In kernel 4.14, PAT is skipped to initialize if MTRR is not enabled,
while graphics driver need set WC to GGTT memory to accelerate memcpy,
if PAT is not initialized, default PAT register will treat UC- as
uncacheable, which will impact gfx performance. Change PAT default
register value to treat UC- as WC to workaroud this problem.
Revert me when PAT/MTRR strong correlation is removed in kernel.
Signed-off-by: Fei Jiang <fei.jiang@intel.com>
Switch all the referenced virtual address to physical address
include ept mapping, vmcs field, vmxon, vmclear, and vmptrld.
Signed-off-by: Zheng, Gen <gen.zheng@intel.com>
Reviewed-by: Chen, Jason Cl <jason.cj.chen@intel.com>
Reviewed-by: Yakui, Zhao <yakui.zhao@intel.com>
Signed-off-by: Zheng, Gen <gen.zheng@intel.com>
Before this patch, guest temporary page tables were generated by hardcode
at compile time, HV will copy this page tables to guest before guest
launch.
This patch creates temporary page tables at runtime for the range of 0~4G,
and create page tables to cover new range(511G~511G+16M) with trusty
requirement.
Signed-off-by: Mingqiang Chi <mingqiang.chi@intel.com>
Reviewed-by: Jason Chen CJ <jason.cj.chen@intel.com>
Acked-by: Eddie Dong <eddie.dong@intel.com>
eptp should be record as PA.
this patch changed nworld_eptp, sworld_eptp and m2p eptp to PA type,
necessary HPA2HVA/HVA2HPA transition is used for them after the change.
Signed-off-by: Jason Chen CJ <jason.cj.chen@intel.com>
Acked-by: Eddie Dong <eddie.dong@intel.com>
enable TSC offset in VMX, so if TSC MSR is changed by guest OS,
write a caculated value into TSC-offset, then host TSC will not be changed.
Signed-off-by: Minggui Cao <minggui.cao@intel.com>
Reviewed-by: Zhao Yakui <yakui.zhao@intel.com>
Reviewed-by: He, Min <min.he@intel.com>
Reviewed-by: Jason Chen CJ <jason.cj.chen@intel.com>
Acked-by: Eddie Dong <eddie.dong@intel.com>
enable Xsave feature and pass-through it to guests
update based on v2:
- enable host xsave before expose it to guests.
- add validation for the value to be set to 'xcr0' before call xsetbv
when handling xsetbv vmexit.
- tested in SOS guest, created two threads to do different
FP calculations,test code runs in user land of sos.
Signed-off-by: Yonghua Huang <yonghua.huang@intel.com>
Acked-by: Eddie Dong <eddie.dong@intel.com>
Add a global boot_cpu_data to cache common cpu capbility/feature
for detect cpu capbility/feature.
Signed-off-by: Li, Fei1 <fei1.li@intel.com>
Acked-by: Xu, Anthony <anthony.xu@intel.com>
Acked-by: Eddie Dong <eddie.dong@intel.com>
this patch is to detect and enable only APICv features which
are actually supported by the processor, instead fo tuning on
all features by default.
Signed-off-by: Yonghua Huang <yonghua.huang@intel.com>
this patch save native lapic configuration and restore it to vm0's vlapic
before its running, then doing hpet timer interrupt injection through vlapic
interface -- this will not mess up vlapic and we can see hpet
timer interrupt coming continuously.
Signed-off-by: Jason Chen CJ <jason.cj.chen@intel.com>
we added uefi stub for hv, and want vm0 continue running under uefi env to
boot other uefi payload (osloader or bzImage).
during this, the uefi timer irq need be handled elegantly.
there are 3 types for uefi timer:
1. 8254 based on IRQ0 of PIC
2. HPET based on IOAPIC
3. HPET based on MSI
currently, we only support type 3 (HPET+MSI). But we are following a
in-correct flow to handle this timer interrupt:
- we set VMX_ENTRY_INT_INFO_FIELD directly if a timer interrupt happened
before vcpu launching, this will make its vlapic mess up, which finally
cause hpet timer stop.
this patch remove this in-correct approach, the new approach patch will
be followed by next patch.
Signed-off-by: Jason Chen CJ <jason.cj.chen@intel.com>
add key info structure
add sworld_eptp in vm structure, and rename ept->nworld_eptp
add secure world control structure
Change-Id:
Tracked-On:220921
Signed-off-by: Mingqiang Chi <mingqiang.chi@intel.com>
Huihuang Shi