58 lines
2.1 KiB
Plaintext
58 lines
2.1 KiB
Plaintext
Title: Bluetooth tester application
|
|
|
|
Description:
|
|
|
|
Tester application uses binary protocol to control Zephyr stack and is aimed at
|
|
automated testing. It requires two serial ports to operate.
|
|
The first serial is used by Bluetooth Testing Protocol (BTP) to drive Bluetooth
|
|
stack. BTP commands and events are received and buffered for further processing
|
|
over the same serial.
|
|
|
|
--------------------------------------------------------------------------------
|
|
|
|
Supported Profiles:
|
|
|
|
GAP, GATT, SM
|
|
--------------------------------------------------------------------------------
|
|
|
|
Building and running on QEMU:
|
|
|
|
QEMU should have connection with the external host Bluetooth hardware.
|
|
The btproxy tool from BlueZ can be used to give access to a Bluetooth controller
|
|
attached to the Linux host OS:
|
|
|
|
$ sudo tools/btproxy -u
|
|
Listening on /tmp/bt-server-bredr
|
|
|
|
/tmp/bt-server-bredr option is already set in Makefile through QEMU_EXTRA_FLAGS.
|
|
|
|
To build tester application for QEMU use BOARD=qemu_cortex_m3 and
|
|
CONF_FILE=qemu.conf. After this qemu can be started through the "run"
|
|
build target.
|
|
|
|
Note: Target board have to support enough UARTs for BTP and controller.
|
|
We recommend using qemu_cortex_m3.
|
|
|
|
'bt-stack-tester' UNIX socket (previously set in Makefile) can be used for now
|
|
to control tester application.
|
|
--------------------------------------------------------------------------------
|
|
|
|
Building and running on Arduino 101:
|
|
|
|
Arduino 101 is equipped with Nordic nRF51 Bluetooth LE controller.
|
|
Please refer to the Zephyr Project docs [1] to see how to build and flash the
|
|
controller with the HCI Bluetooth LE firmware.
|
|
|
|
Next, build and flash tester application by employing the "flash" build
|
|
target.
|
|
|
|
While running tester application on Arduino 101, serial converter, typically
|
|
UART <-> USB is required by BTP to operate. Connect Arduino 101 Tx and Rx lines
|
|
(0 and 1 ports on Arduino 101 board) through the UART converter to the host
|
|
USB port.
|
|
|
|
Use serial client, e.g. PUTTY to communicate over the serial port
|
|
(typically /dev/ttyUSBx) with the tester using BTP.
|
|
|
|
[1] https://www.zephyrproject.org/doc/boards/x86/arduino_101/doc/board.html#flashing-the-bluetooth-core
|