Arvin Farahmand a687610b80 drivers: uart_sam0: add support for collision detection error ... Automatic collision detection for half-duplex mode can be enabled by setting `collision-detection` proprety for uart hardware in the dts file. If the transmitted bit does not match the received bit an error is raised. This is useful in RS-485 half-duplex mode. Signed-off-by: Arvin Farahmand <arvinf@ip-logix.com>		2021-05-03 19:57:07 -04:00
..
arc	pinmux: hsdk: Convert ARC HSDK pinmux to be devicetree based	2021-02-15 08:29:56 -05:00
arm	dts/arm/st: h7: Add clocks nodes	2021-05-03 10:56:05 +02:00
arm64	board: nxp_ls1046ardb: add 2 cores smp for running in Jailhouse	2021-04-22 11:29:54 +02:00
bindings	drivers: uart_sam0: add support for collision detection error	2021-05-03 19:57:07 -04:00
common	dts/arm: stm32: Add clocks nodes on stm32wb,l4 and stm32f4 series	2021-04-27 11:53:37 +02:00
nios2	drivers: i2c: nios2: get IRQ and IRQ priority from DTS	2021-03-03 11:55:03 -06:00
posix	…
riscv	dts: it8xxx2: change flash size to 1M byte	2021-04-29 16:47:47 -05:00
sparc	soc: GR716A LEON3FT Microcontroller	2020-11-13 14:53:55 -08:00
x86	soc: x86: add Lakemont SoC	2021-02-19 18:51:04 -05:00
xtensa	esp32: drivers: spi_flash: add host flash support	2021-03-06 09:34:35 -05:00
Kconfig	…
binding-template.yaml	doc: devicetree: overhaul bindings guide	2021-04-22 15:32:10 +02:00