zephyr

History

Andrew Boie 138579a3ad samples: add some missing testcase.ini Issue: ZEP-1768 Change-Id: Ia59e02bdaf9302b991f0423ef5eba7b0102877b0 Signed-off-by: Andrew Boie <andrew.p.boie@intel.com>		2017-02-23 13:28:03 +00:00
..
src	license: Replace Apache boilerplate with SPDX tag	2017-01-19 03:50:58 +00:00
Makefile	samples: tests: remove obsolete KERNEL_TYPE and kernel variables	2016-11-04 15:47:25 -04:00
README.rst	doc: fix .rst files canonical heading order	2017-01-20 16:06:36 -08:00
prj.conf	kernel: remove dependency on CONFIG_NANO_TIMERS/TIMEOUTS	2017-01-08 18:09:52 +00:00
testcase.ini	samples: add some missing testcase.ini	2017-02-23 13:28:03 +00:00

README.rst

Blinky Application
##################

Overview
********

The Blinky example shows how to configure GPIO pins as outputs which can also be
used to drive LEDs on the hardware usually delivered as "User LEDs" on many of
the supported boards in Zephyr.

Requirements
************

The demo assumes that an LED is connected to one of GPIO lines. The
sample code is configured to work on boards with user defined buttons and that
have defined the LED0\_* variables in :file:`board.h`.

The :file:`board.h` must define the following variables:

- LED0_GPIO_PORT
- LED0_GPIO_PIN


Building and Running
********************

This samples does not output anything to the console.  It can be built and
flashed to a board as follows:

.. code-block:: console

   $ cd samples/basic/blinky
   $ make BOARD=arduino_101
   $ make BOARD=arduino_101 flash

After flashing the image to the board, the user LED on the board should start to
blink.