zephyr/soc/arm/st_stm32/common/soc_config.c

70 lines
1.9 KiB
C

/*
* Copyright (c) 2021 Andrés Manelli <am@toroid.io>
*
* SPDX-License-Identifier: Apache-2.0
*/
/** @file
* @brief System module to support early STM32 MCU configuration
*/
#include <device.h>
#include <init.h>
#include <soc.h>
#include <arch/cpu.h>
#include <stm32_ll_system.h>
#include <stm32_ll_bus.h>
/**
* @brief Perform SoC configuration at boot.
*
* This should be run early during the boot process but after basic hardware
* initialization is done.
*
* @return 0
*/
static int st_stm32_common_config(const struct device *dev)
{
#ifdef CONFIG_LOG_BACKEND_SWO
/* TRACE pin assignment for asynchronous mode */
DBGMCU->CR &= ~DBGMCU_CR_TRACE_MODE_Msk;
/* Enable the SWO pin */
DBGMCU->CR |= DBGMCU_CR_TRACE_IOEN;
#endif
#if defined(CONFIG_USE_SEGGER_RTT)
/* On some STM32 boards, for unclear reason,
* RTT feature is working with realtime update only when
* - one of the DMA is clocked.
* See https://github.com/zephyrproject-rtos/zephyr/issues/34324
*/
#if defined(__HAL_RCC_DMA1_CLK_ENABLE)
__HAL_RCC_DMA1_CLK_ENABLE();
#endif /* __HAL_RCC_DMA1_CLK_ENABLE */
/* On some STM32 boards, for unclear reason,
* RTT feature is working with realtime update only when
* - one of the DBGMCU bit STOP/STANDBY/SLEEP is set
* See https://github.com/zephyrproject-rtos/zephyr/issues/34324
*/
#if defined(LL_APB1_GRP1_PERIPH_DBGMCU)
LL_APB1_GRP1_EnableClock(LL_APB1_GRP1_PERIPH_DBGMCU);
#elif defined(LL_APB1_GRP2_PERIPH_DBGMCU)
LL_APB1_GRP2_EnableClock(LL_APB1_GRP2_PERIPH_DBGMCU);
#elif defined(LL_APB2_GRP1_PERIPH_DBGMCU)
LL_APB2_GRP1_EnableClock(LL_APB2_GRP1_PERIPH_DBGMCU);
#endif /* LL_APB1_GRP1_PERIPH_DBGMCU */
#if defined(CONFIG_SOC_SERIES_STM32H7X) || defined(CONFIG_SOC_SERIES_STM32MP1X)
HAL_EnableDBGSleepMode();
#else
LL_DBGMCU_EnableDBGStopMode();
#endif /* CONFIG_SOC_SERIES_STM32H7X || CONFIG_SOC_SERIES_STM32MP1X */
#endif /* CONFIG_USE_SEGGER_RTT */
return 0;
}
SYS_INIT(st_stm32_common_config, PRE_KERNEL_1, 1);