zephyr

History

Reto Schneider 7eabab2f5d samples, tests: Use semi-accurate project names When using an IDE (e.g. Eclipse, Qt Creator), the project name gets displayed. This greatly simplifies the navigation between projects when having many of them open at the same time. Naming every project "NONE" defeats this functionality. This patch tries to use sensible project names while not duplicating too much of what is already represented in the path. This is done by using the name of the directory the relevant CMakeLists.txt file is stored in. To ensure unique project names in the samples (and again, in the tests folder) folder, small manual adjustments have been done. Signed-off-by: Reto Schneider <code@reto-schneider.ch>		2018-10-27 21:31:25 -04:00
..
src	sys_clock: Fix unsafe tick count usage	2018-10-16 15:03:10 -04:00
CMakeLists.txt	samples, tests: Use semi-accurate project names	2018-10-27 21:31:25 -04:00
README.txt	…
prj.conf	…
prj_x86.conf	…
testcase.yaml	tests: remove bat_commit, replace core with kernel	2018-10-16 09:17:51 -04:00

README.txt

Title: Shared Floating Point Support

Description:

This test uses two tasks to independently compute pi, while two other tasks
load and store floating point registers and check for corruption. This tests
the ability of tasks to safely share floating point hardware resources, even
when switching occurs preemptively. (Note that both sets of tests run
concurrently even though they report their progress at different times.)

The demonstration utilizes mutex APIs, timers, semaphores,
round robin scheduling, and floating point support.

--------------------------------------------------------------------------------

Building and Running Project:

This project outputs to the console.  It can be built and executed
on QEMU as follows:

    make run

--------------------------------------------------------------------------------

Troubleshooting:

Problems caused by out-dated project information can be addressed by
issuing one of the following commands then rebuilding the project:

    make clean          # discard results of previous builds
                        # but keep existing configuration info
or
    make pristine       # discard results of previous builds
                        # and restore pre-defined configuration info

--------------------------------------------------------------------------------

Advanced:

Depending upon the board's speed, the frequency of test output may range from
every few seconds to every few minutes. The speed of the test can be controlled
through the variable PI_NUM_ITERATIONS (default 700000). Lowering this value
will increase the test's speed, but at the expense of the calculation's
precision.

    make run PI_NUM_ITERATIONS=100000

--------------------------------------------------------------------------------

Sample Output:

***** BOOTING ZEPHYR OS vxxx - BUILD: Jan xxxx *****
Floating point sharing tests started
===================================================================
Load and store OK after 100 (high) + 47119 (low) tests
Pi calculation OK after 50 (high) + 2 (low) tests (computed 3.141594)
Load and store OK after 200 (high) + 94186 (low) tests
Load and store OK after 300 (high) + 142416 (low) tests
Pi calculation OK after 150 (high) + 7 (low) tests (computed 3.141594)
Load and store OK after 400 (high) + 190736 (low) tests
Load and store OK after 500 (high) + 238618 (low) tests
===================================================================
PASS - load_store_high.
===================================================================
PROJECT EXECUTION SUCCESSFUL