61 lines
2.3 KiB
ReStructuredText
61 lines
2.3 KiB
ReStructuredText
.. _ble_mesh_provisioner:
|
|
|
|
Bluetooth: Mesh Provisioner
|
|
###########################
|
|
|
|
Overview
|
|
********
|
|
|
|
This sample demonstrates how to use the Bluetooth Mesh APIs related to
|
|
provisioning and using the Configuration Database (CDB). It is intended
|
|
to be tested together with a device capable of being provisioned. For
|
|
example, one could use the sample in
|
|
:zephyr_file:`samples/bluetooth/mesh`
|
|
or :zephyr_file:`tests/bluetooth/mesh_shell`.
|
|
|
|
The application provisions itself and loads the CDB with an application
|
|
key, then waits to receive an Unprovisioned Beacon from a device. If the
|
|
board has a push button connected via GPIO and configured using the
|
|
``sw0`` :ref:`devicetree <dt-guide>` alias, the application then waits
|
|
for the user to press the button, which will trigger provisioning using
|
|
PB-ADV. If the board doesn't have the push button, the sample will
|
|
provision detected devices automatically. Once provisioning is done, the
|
|
node will be present in the CDB but not yet marked as configured. The
|
|
application will notice the unconfigured node and start configuring it.
|
|
If no errors are encountered, the node is marked as configured.
|
|
|
|
The configuration of a node involves adding an application key, getting
|
|
the composition data, and binding all its models to the application key.
|
|
|
|
Requirements
|
|
************
|
|
|
|
* A board with Bluetooth LE support, or
|
|
* QEMU with BlueZ running on the host
|
|
|
|
Building and Running
|
|
********************
|
|
|
|
This sample can be found under
|
|
:zephyr_file:`samples/bluetooth/mesh_provisioner` in the Zephyr tree.
|
|
|
|
See :ref:`bluetooth samples section <bluetooth-samples>` for details on
|
|
how to run the sample inside QEMU.
|
|
|
|
For other boards, build and flash the application as follows:
|
|
|
|
.. zephyr-app-commands::
|
|
:zephyr-app: samples/bluetooth/mesh_provisioner
|
|
:board: <board>
|
|
:goals: flash
|
|
:compact:
|
|
|
|
Refer to your :ref:`board's documentation <boards>` for alternative
|
|
flash instructions if your board doesn't support the ``flash`` target.
|
|
|
|
To run the application on an :ref:`nrf5340dk_nrf5340`, a Bluetooth controller application
|
|
must also run on the network core. The :ref:`bluetooth-hci-ipc-sample` sample
|
|
application may be used. Build this sample with configuration
|
|
:zephyr_file:`samples/bluetooth/hci_ipc/nrf5340_cpunet_bt_mesh-bt_ll_sw_split.conf`
|
|
to enable mesh support.
|