zephyr

History

Patrik Flykt 24d71431e9 all: Add 'U' suffix when using unsigned variables Add a 'U' suffix to values when computing and comparing against unsigned variables. Signed-off-by: Patrik Flykt <patrik.flykt@intel.com>		2019-03-28 17:15:58 -05:00
..
src	all: Add 'U' suffix when using unsigned variables	2019-03-28 17:15:58 -05:00
CMakeLists.txt	…
README.rst	…
prj.conf	…
sample.yaml	…

README.rst

.. _fade-led-sample:

PWM: Fade LED
#############

Overview
********

This is a sample app which fades a LED using PWM.

The LED will start from dark and increases its
brightness gradually for 10 seconds. Then, the
brightness reduces gradually for 10 seconds and
finally the LED becomes dark again. The LED will
repeat this cycle for ever.

Wiring
******

Nucleo_F401RE, Nucleo_L476RG
============================
Connect PWM2(PA0) to LED

Nucleo_F103RB
=============
Connect PWM1(PA8) to LED

Nucleo_L496ZG
=============
No special board setup is necessary because there are three on-board LEDs (red,
green, blue) connected to the Nucleo's PWM.

Hexiwear K64
============
No special board setup is necessary because there is an on-board RGB LED
connected to the K64 PWM.

nrf52840_pca10056
=================
No special board setup is necessary because there is an on-board LED connected.

Arduino 101 and Quark D2000 CRB
===============================
You will need to connect the LED to ground and PWM0 via
the shield. You may need a current limiting resistor. See
your LED datasheet.


Building and Running
********************

This sample can be built for multiple boards, in this example we will build it
for the arduino_101 board:

.. zephyr-app-commands::
   :zephyr-app: samples/basic/fade_led
   :board: nrf52840_pca10056
   :goals: build flash
   :compact: