127 lines
4.4 KiB
C
127 lines
4.4 KiB
C
/* pinmux_board_frdm_k64f.c - pin out mapping for the Freescale FRDM-K64F board */
|
|
|
|
/*
|
|
* Copyright (c) 2016 Intel Corporation
|
|
*
|
|
* Licensed under the Apache License, Version 2.0 (the "License");
|
|
* you may not use this file except in compliance with the License.
|
|
* You may obtain a copy of the License at
|
|
*
|
|
* http://www.apache.org/licenses/LICENSE-2.0
|
|
*
|
|
* Unless required by applicable law or agreed to in writing, software
|
|
* distributed under the License is distributed on an "AS IS" BASIS,
|
|
* WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
|
|
* See the License for the specific language governing permissions and
|
|
* limitations under the License.
|
|
*/
|
|
|
|
#include <kernel.h>
|
|
#include <device.h>
|
|
#include <init.h>
|
|
#include <sys_io.h>
|
|
#include <pinmux.h>
|
|
#include <pinmux/pinmux.h>
|
|
#include <pinmux/k64/pinmux.h>
|
|
|
|
/*
|
|
* I/O pin configuration
|
|
*/
|
|
|
|
/*
|
|
* Alter this table to change the default Arduino pin settings on the Freescale
|
|
* FRDM-K64F boards. Specifically, change the PINMUX_* values to represent
|
|
* the functionality desired.
|
|
*
|
|
* The FRDM-K64F board routes the PTA0/1/2 pins for JTAG/SWD signals that
|
|
* are used for the OpenSDAv2 debug interface. These pins are also routed to
|
|
* the Arduino header pins as D8, D3 and D5, respectively.
|
|
* Since the K64 MCU configures these pins for JTAG/SWD signaling at reset,
|
|
* they should only be re-configured if the debug interface is not used.
|
|
*
|
|
*/
|
|
static const struct pin_config mux_config[] = {
|
|
/* pin, selected mode */
|
|
{ K64_PIN_PTC16, K64_PINMUX_ALT_3 }, /* UART3 RX */
|
|
{ K64_PIN_PTC17, K64_PINMUX_ALT_3 }, /* UART3 TX */
|
|
{ K64_PIN_PTB9, K64_PINMUX_FUNC_GPIO },
|
|
#ifndef CONFIG_PRESERVE_JTAG_IO_PINS
|
|
{ K64_PIN_PTA1, K64_PINMUX_FUNC_GPIO },
|
|
#endif
|
|
{ K64_PIN_PTB23, K64_PINMUX_FUNC_GPIO },
|
|
#ifndef CONFIG_PRESERVE_JTAG_IO_PINS
|
|
{ K64_PIN_PTA2, K64_PINMUX_FUNC_GPIO },
|
|
#endif
|
|
{ K64_PIN_PTC2, K64_PINMUX_FUNC_GPIO },
|
|
{ K64_PIN_PTC3, K64_PINMUX_FUNC_GPIO },
|
|
#ifndef CONFIG_PRESERVE_JTAG_IO_PINS
|
|
{ K64_PIN_PTA0, K64_PINMUX_FUNC_GPIO },
|
|
#endif
|
|
{ K64_PIN_PTC4, K64_PINMUX_FUNC_GPIO },
|
|
|
|
{ K64_PIN_PTC6, K64_PINMUX_FUNC_GPIO }, /* SW2 / FXOS8700 INT1 */
|
|
{ K64_PIN_PTA4, K64_PINMUX_FUNC_GPIO }, /* SW3 */
|
|
|
|
{ K64_PIN_PTB22, K64_PINMUX_FUNC_GPIO }, /* Red LED */
|
|
{ K64_PIN_PTE26, K64_PINMUX_FUNC_GPIO }, /* Green LED */
|
|
{ K64_PIN_PTB21, K64_PINMUX_FUNC_GPIO }, /* Blue LED */
|
|
|
|
/* SPI 0 */
|
|
#ifdef CONFIG_SPI_0
|
|
{ K64_PIN_PTD0, K64_PINMUX_FUNC_SPI },
|
|
{ K64_PIN_PTD2, K64_PINMUX_FUNC_SPI },
|
|
{ K64_PIN_PTD3, K64_PINMUX_FUNC_SPI },
|
|
{ K64_PIN_PTD1, K64_PINMUX_FUNC_SPI },
|
|
#else
|
|
{ K64_PIN_PTD0, K64_PINMUX_FUNC_GPIO },
|
|
{ K64_PIN_PTD2, K64_PINMUX_FUNC_GPIO },
|
|
{ K64_PIN_PTD3, K64_PINMUX_FUNC_GPIO },
|
|
{ K64_PIN_PTD1, K64_PINMUX_FUNC_GPIO },
|
|
#endif
|
|
|
|
/* I2C0_SDA */
|
|
{ K64_PIN_PTE25, (K64_PINMUX_ALT_5 | K64_PINMUX_OPEN_DRN_ENABLE) },
|
|
/* I2C0_SCL */
|
|
{ K64_PIN_PTE24, (K64_PINMUX_ALT_5 | K64_PINMUX_OPEN_DRN_ENABLE) },
|
|
{ K64_PIN_PTB2, K64_PINMUX_FUNC_ANALOG }, /* ADC0_SE12/Analog In 0 */
|
|
{ K64_PIN_PTB3, K64_PINMUX_FUNC_ANALOG }, /* ADC0_SE13/Analog In 1 */
|
|
{ K64_PIN_PTB10, K64_PINMUX_FUNC_ANALOG }, /* ADC1_SE14/Analog In 2 */
|
|
{ K64_PIN_PTB11, K64_PINMUX_FUNC_ANALOG }, /* ADC1_SE15/Analog In 3 */
|
|
{ K64_PIN_PTC11, K64_PINMUX_FUNC_ANALOG }, /* ADC1_SE7b/Analog In 4 */
|
|
{ K64_PIN_PTC10, K64_PINMUX_FUNC_ANALOG }, /* ADC1_SE6b/Analog In 5 */
|
|
|
|
#if CONFIG_ETH_KSDK_0
|
|
{ K64_PIN_PTA5, K64_PINMUX_FUNC_ETHERNET},
|
|
{ K64_PIN_PTA12, K64_PINMUX_FUNC_ETHERNET},
|
|
{ K64_PIN_PTA13, K64_PINMUX_FUNC_ETHERNET},
|
|
{ K64_PIN_PTA14, K64_PINMUX_FUNC_ETHERNET},
|
|
{ K64_PIN_PTA15, K64_PINMUX_FUNC_ETHERNET},
|
|
{ K64_PIN_PTA16, K64_PINMUX_FUNC_ETHERNET},
|
|
{ K64_PIN_PTA17, K64_PINMUX_FUNC_ETHERNET},
|
|
{ K64_PIN_PTA28, K64_PINMUX_FUNC_ETHERNET},
|
|
{ K64_PIN_PTB0, (K64_PINMUX_FUNC_ETHERNET |
|
|
K64_PINMUX_OPEN_DRN_ENABLE |
|
|
K64_PINMUX_PULL_ENABLE |
|
|
K64_PINMUX_PULL_UP)},
|
|
{ K64_PIN_PTB1, K64_PINMUX_FUNC_ETHERNET},
|
|
{ K64_PIN_PTC16, K64_PINMUX_FUNC_ETHERNET},
|
|
{ K64_PIN_PTC17, K64_PINMUX_FUNC_ETHERNET},
|
|
{ K64_PIN_PTC18, K64_PINMUX_FUNC_ETHERNET},
|
|
{ K64_PIN_PTC19, K64_PINMUX_FUNC_ETHERNET},
|
|
#endif
|
|
};
|
|
|
|
static int fsl_frdm_k64f_pin_init(struct device *arg)
|
|
{
|
|
ARG_UNUSED(arg);
|
|
|
|
/* configure the pins from the default mapping above */
|
|
for (int i = 0; i < ARRAY_SIZE(mux_config); i++) {
|
|
_fsl_k64_set_pin(mux_config[i].pin_num, mux_config[i].mode);
|
|
}
|
|
|
|
return 0;
|
|
}
|
|
|
|
SYS_INIT(fsl_frdm_k64f_pin_init, POST_KERNEL, CONFIG_PINMUX_INIT_PRIORITY);
|