zephyr

History

Torsten Rasmussen 1cccc8a8fe cmake: increase minimal required version to 3.20.0 Move to CMake 3.20.0. At the Toolchain WG it was decided to move to CMake 3.20.0. The main reason for increasing CMake version is better toolchain support. Better toolchain support is added in the following CMake versions: - armclang, CMake 3.15 - Intel oneAPI, CMake 3.20 - IAR, CMake 3.15 and 3.20 Signed-off-by: Torsten Rasmussen <Torsten.Rasmussen@nordicsemi.no>		2021-08-20 09:47:34 +02:00
..
src	samples: net: Fix vlan error message in samples	2021-01-07 09:52:21 -06:00
CMakeLists.txt	cmake: increase minimal required version to 3.20.0	2021-08-20 09:47:34 +02:00
Kconfig	kconfig: Clean up header comments and make them consistent	2019-11-04 17:31:27 -05:00
README.rst	doc: use :zephyr_file: where appropriate	2019-03-09 09:50:27 -05:00
prj.conf	…
sample.yaml	sanitycheck: inclusive language	2020-08-27 07:04:07 -04:00

README.rst

.. _lldp-sample:

LLDP Sample Application
#######################

Overview
********

The Link Layer Discovery Protocol sample application for Zephyr will enable
LLDP support and setup VLANs if needed.

The source code for this sample application can be found at:
:zephyr_file:`samples/net/lldp`.

Requirements
************

- :ref:`networking_with_host`

Building and Running
********************

A good way to run this sample LLDP application is inside QEMU,
as described in :ref:`networking_with_qemu` or with embedded device like
FRDM-K64F. Note that LLDP is only supported for boards that have an ethernet
port.

Follow these steps to build the LLDP sample application:

.. zephyr-app-commands::
   :zephyr-app: samples/net/lldp
   :board: <board to use>
   :conf: prj.conf
   :goals: build
   :compact:

Setting up Linux Host
=====================

If you need VLAN support in your network, then the
:zephyr_file:`samples/net/vlan/vlan-setup-linux.sh` provides a script that can be
executed on the Linux host. It creates two VLANs on the Linux host and creates
routes to Zephyr.