zephyr

History

Torsten Rasmussen 407b49b35c cmake: use find_package to locate Zephyr Using find_package to locate Zephyr. Old behavior was to use $ENV{ZEPHYR_BASE} for inclusion of boiler plate code. Whenever an automatic run of CMake happend by the build system / IDE then it was required that ZEPHYR_BASE was defined. Using ZEPHYR_BASE only to locate the Zephyr package allows CMake to cache the base variable and thus allowing subsequent invocation even if ZEPHYR_BASE is not set in the environment. It also removes the risk of strange build results if a user switchs between different Zephyr based project folders and forgetting to reset ZEPHYR_BASE before running ninja / make. Signed-off-by: Torsten Rasmussen <Torsten.Rasmussen@nordicsemi.no>		2020-03-27 16:23:46 +01:00
..
src	…
CMakeLists.txt	cmake: use find_package to locate Zephyr	2020-03-27 16:23:46 +01:00
README.rst	…
prj.conf	…
prj_single.conf	…
sample.yaml	…

README.rst

.. _mpu_test:

Memory Protection Unit (MPU) TEST
#################################

Overview
********
This test provides a set options to check the correct MPU configuration
against the following security issues:

* Read at an address that is reserved in the memory map.
* Write into the boot Flash/ROM.
* Run code located in SRAM.

If the MPU configuration is correct each option selected ends up in an MPU
fault.

Building and Running
********************

This project can be built and executed as follows:

.. zephyr-app-commands::
   :zephyr-app: samples/mpu/mpu_test
   :board: v2m_beetle
   :goals: build flash
   :compact:

To build the single thread version, use the supplied configuration file for
single thread: :file:`prj_single.conf`:

.. zephyr-app-commands::
   :zephyr-app: samples/mpu/mpu_test
   :board: v2m_beetle
   :conf: prj_single.conf
   :goals: run
   :compact:

To build a version that allows writes to the flash device, edit
``prj.conf``, and follow the directions in the comments to enable the
proper configs.

Sample Output
=============

.. code-block:: console

  uart:~$ mpu read
  ***** BUS FAULT *****
    Precise data bus error
    BFAR Address: 0x24000000
  ***** Hardware exception *****
  Current thread ID = 0x20000400
  Faulting instruction address = 0x80004a8
  Fatal fault in thread 0x20000400! Aborting.