135 lines
3.7 KiB
C
135 lines
3.7 KiB
C
/*
|
|
* Copyright (c) 2016 Intel Corporation
|
|
*
|
|
* Licensed under the Apache License, Version 2.0 (the "License");
|
|
* you may not use this file except in compliance with the License.
|
|
* You may obtain a copy of the License at
|
|
*
|
|
* http://www.apache.org/licenses/LICENSE-2.0
|
|
*
|
|
* Unless required by applicable law or agreed to in writing, software
|
|
* distributed under the License is distributed on an "AS IS" BASIS,
|
|
* WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
|
|
* See the License for the specific language governing permissions and
|
|
* limitations under the License.
|
|
*/
|
|
|
|
#include <i2c.h>
|
|
#include <init.h>
|
|
#include <sensor.h>
|
|
#include <misc/__assert.h>
|
|
|
|
#include "lis3dh.h"
|
|
|
|
static void lis3dh_convert(struct sensor_value *val, int64_t raw_val)
|
|
{
|
|
/* val = raw_val * LIS3DH_ACCEL_SCALE / (10^6 * (2^16 - 1)) */
|
|
val->type = SENSOR_VALUE_TYPE_INT_PLUS_MICRO;
|
|
raw_val = raw_val * LIS3DH_ACCEL_SCALE / 1000000;
|
|
val->val1 = raw_val / 0xFFFF;
|
|
val->val2 = (raw_val % 0xFFFF) * 1000000 / 0xFFFF;
|
|
|
|
/* normalize val to make sure val->val2 is positive */
|
|
if (val->val2 < 0) {
|
|
val->val1 -= 1;
|
|
val->val2 += 1000000;
|
|
}
|
|
}
|
|
|
|
static int lis3dh_channel_get(struct device *dev,
|
|
enum sensor_channel chan,
|
|
struct sensor_value *val)
|
|
{
|
|
struct lis3dh_data *drv_data = dev->driver_data;
|
|
|
|
if (chan == SENSOR_CHAN_ACCEL_X) {
|
|
lis3dh_convert(val, drv_data->x_sample);
|
|
} else if (chan == SENSOR_CHAN_ACCEL_Y) {
|
|
lis3dh_convert(val, drv_data->y_sample);
|
|
} else if (chan == SENSOR_CHAN_ACCEL_Z) {
|
|
lis3dh_convert(val, drv_data->z_sample);
|
|
} else if (chan == SENSOR_CHAN_ACCEL_ANY) {
|
|
lis3dh_convert(val, drv_data->x_sample);
|
|
lis3dh_convert(val + 1, drv_data->y_sample);
|
|
lis3dh_convert(val + 2, drv_data->z_sample);
|
|
} else {
|
|
return -ENOTSUP;
|
|
}
|
|
|
|
return 0;
|
|
}
|
|
|
|
int lis3dh_sample_fetch(struct device *dev, enum sensor_channel chan)
|
|
{
|
|
struct lis3dh_data *drv_data = dev->driver_data;
|
|
uint8_t buf[6];
|
|
|
|
__ASSERT_NO_MSG(chan == SENSOR_CHAN_ALL || chan == SENSOR_CHAN_ACCEL_ANY);
|
|
|
|
/*
|
|
* since all accel data register addresses are consecutive,
|
|
* a burst read can be used to read all the samples
|
|
*/
|
|
if (i2c_burst_read(drv_data->i2c, LIS3DH_I2C_ADDRESS,
|
|
LIS3DH_REG_ACCEL_X_LSB, buf, 6) < 0) {
|
|
SYS_LOG_DBG("Could not read accel axis data");
|
|
return -EIO;
|
|
}
|
|
|
|
drv_data->x_sample = (buf[1] << 8) | buf[0];
|
|
drv_data->y_sample = (buf[3] << 8) | buf[2];
|
|
drv_data->z_sample = (buf[5] << 8) | buf[4];
|
|
|
|
return 0;
|
|
}
|
|
|
|
static const struct sensor_driver_api lis3dh_driver_api = {
|
|
#if CONFIG_LIS3DH_TRIGGER
|
|
.trigger_set = lis3dh_trigger_set,
|
|
#endif
|
|
.sample_fetch = lis3dh_sample_fetch,
|
|
.channel_get = lis3dh_channel_get,
|
|
};
|
|
|
|
int lis3dh_init(struct device *dev)
|
|
{
|
|
struct lis3dh_data *drv_data = dev->driver_data;
|
|
|
|
drv_data->i2c = device_get_binding(CONFIG_LIS3DH_I2C_MASTER_DEV_NAME);
|
|
if (drv_data->i2c == NULL) {
|
|
SYS_LOG_DBG("Could not get pointer to %s device",
|
|
CONFIG_LIS3DH_I2C_MASTER_DEV_NAME);
|
|
return -EINVAL;
|
|
}
|
|
|
|
/* enable accel measurements and set power mode and data rate */
|
|
if (i2c_reg_write_byte(drv_data->i2c, LIS3DH_I2C_ADDRESS,
|
|
LIS3DH_REG_CTRL1, LIS3DH_ACCEL_EN_BITS |
|
|
LIS3DH_LP_EN_BIT | LIS3DH_ODR_BITS) < 0) {
|
|
SYS_LOG_DBG("Failed to configure chip.");
|
|
}
|
|
|
|
/* set full scale range */
|
|
if (i2c_reg_write_byte(drv_data->i2c, LIS3DH_I2C_ADDRESS,
|
|
LIS3DH_REG_CTRL4, LIS3DH_FS_BITS) < 0) {
|
|
SYS_LOG_DBG("Failed to set full scale range.");
|
|
return -EIO;
|
|
}
|
|
|
|
#ifdef CONFIG_LIS3DH_TRIGGER
|
|
if (lis3dh_init_interrupt(dev) < 0) {
|
|
SYS_LOG_DBG("Failed to initialize interrupts.");
|
|
return -EIO;
|
|
}
|
|
#endif
|
|
|
|
dev->driver_api = &lis3dh_driver_api;
|
|
|
|
return 0;
|
|
}
|
|
|
|
struct lis3dh_data lis3dh_driver;
|
|
|
|
DEVICE_INIT(lis3dh, CONFIG_LIS3DH_NAME, lis3dh_init, &lis3dh_driver,
|
|
NULL, POST_KERNEL, CONFIG_SENSOR_INIT_PRIORITY);
|