zephyr

History

Kumar Gala 9740078d6c samples: net: wpan_serial: Remove dead code related to CONFIG_DCD_DSR CONFIG_DCD_DSR does not exist so the code block associated with it would never be built, so remove it. Signed-off-by: Kumar Gala <kumar.gala@linaro.org>		2019-03-07 10:13:10 -05:00
..
src	samples: net: wpan_serial: Remove dead code related to CONFIG_DCD_DSR	2019-03-07 10:13:10 -05:00
CMakeLists.txt	cmake: increase minimal required version to 3.13.1	2019-01-03 11:51:29 -05:00
README	…
prj.conf	samples: net: wpan_serial: Convert to new logging system	2018-10-04 14:13:57 +03:00
sample.yaml	…

README

Application implementing 802.15.4 "serial-radio" protocol.

How to use:

1. Build and flash Zephyr application to Quark board with 802.15.4 radio,
   at the moment CC2520 radio is supported.
2. Connect board to Linux PC, /dev/ttyACM[number] should appear
3. Run Contiki-based native border router (6lbr, native-router, etc)
     Example for Contiki:
     $ cd examples/ipv6/native-border-router
     $ make
     $ sudo ./border-router.native -v5 -s ttyACM0 fd01::1/64

Now you have Contiki native border router, simple web server should show some
802.15.4 devices. Web server address is printed in the border-router output
screen:
...
Server IPv6 addresses:
 0x62c5c0: =>fd01::212:4b00:531f:113a
...
Go to http://[fd01::212:4b00:531f:113a]/

It shall show you Neighbors and Routes.

PS: Make sure your disto ModemManager is disabled, otherwise it sends AT commands
to our device ;)

$ sudo systemctl disable ModemManager.service