zephyr

History

Torsten Rasmussen 1cccc8a8fe cmake: increase minimal required version to 3.20.0 Move to CMake 3.20.0. At the Toolchain WG it was decided to move to CMake 3.20.0. The main reason for increasing CMake version is better toolchain support. Better toolchain support is added in the following CMake versions: - armclang, CMake 3.15 - Intel oneAPI, CMake 3.20 - IAR, CMake 3.15 and 3.20 Signed-off-by: Torsten Rasmussen <Torsten.Rasmussen@nordicsemi.no>		2021-08-20 09:47:34 +02:00
..
src	…
CMakeLists.txt	cmake: increase minimal required version to 3.20.0	2021-08-20 09:47:34 +02:00
README.rst	…
prj.conf	…
prj_single.conf	…
sample.yaml	sample: mpu: skip the MPU test for Armv8-R AArch64	2021-04-13 07:47:44 -04:00

README.rst

.. _mpu_test:

Memory Protection Unit (MPU) TEST
#################################

Overview
********
This test provides a set options to check the correct MPU configuration
against the following security issues:

* Read at an address that is reserved in the memory map.
* Write into the boot Flash/ROM.
* Run code located in SRAM.

If the MPU configuration is correct each option selected ends up in an MPU
fault.

Building and Running
********************

This project can be built and executed as follows:

.. zephyr-app-commands::
   :zephyr-app: samples/mpu/mpu_test
   :board: v2m_beetle
   :goals: build flash
   :compact:

To build the single thread version, use the supplied configuration file for
single thread: :file:`prj_single.conf`:

.. zephyr-app-commands::
   :zephyr-app: samples/mpu/mpu_test
   :board: v2m_beetle
   :conf: prj_single.conf
   :goals: run
   :compact:

To build a version that allows writes to the flash device, edit
``prj.conf``, and follow the directions in the comments to enable the
proper configs.

Sample Output
=============

.. code-block:: console

  uart:~$ mpu read
  ***** BUS FAULT *****
    Precise data bus error
    BFAR Address: 0x24000000
  ***** Hardware exception *****
  Current thread ID = 0x20000400
  Faulting instruction address = 0x80004a8
  Fatal fault in thread 0x20000400! Aborting.