cbb83d64ab
So far pin identifiers were named after CN7 and CN10 connector names on Nucleo-64 boards. In case of Nucleo-144 there are ST Morpho connectors on both sides, but bigger (up to 72 instead of 38 pins on each side). First 38 pins out of 72 on each side usually map to the same pins (e.g. PA5 being 13th pin on right ST Morpho connector). This means that single ST Morpho connector definition will suffice. Leaving CN7 and CN10 (name of pin headers on Nucleo-64 boards) is confusing in context of Nucleo-144 boards, since corresponding pin headers are named CN11 and CN12. Rename: * s/ST_MORPHO_CN7_/ST_MORPHO_L_/ * s/ST_MORPHO_CN10_/ST_MORPHO_R_/ so that pin identifiers make more sense in context of Nucleo-144 boards. Signed-off-by: Marcin Niestroj <m.niestroj@emb.dev> |
||
|---|---|---|
| .. | ||
| doc | ||
| support | ||
| Kconfig.board | ||
| Kconfig.defconfig | ||
| arduino_r3_connector.dtsi | ||
| board.cmake | ||
| nucleo_f091rc.dts | ||
| nucleo_f091rc.yaml | ||
| nucleo_f091rc_defconfig | ||
| st_morpho_connector.dtsi | ||