zephyr/boards/quark_se_c1000_devboard/board.h

65 lines
1.9 KiB
C

/*
* Copyright (c) 2015 Intel Corporation
*
* Licensed under the Apache License, Version 2.0 (the "License");
* you may not use this file except in compliance with the License.
* You may obtain a copy of the License at
*
* http://www.apache.org/licenses/LICENSE-2.0
*
* Unless required by applicable law or agreed to in writing, software
* distributed under the License is distributed on an "AS IS" BASIS,
* WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
* See the License for the specific language governing permissions and
* limitations under the License.
*/
#ifndef __BOARD_H__
#define __BOARD_H__
#include <soc.h>
/* Push button switch 0 */
#define SW0_GPIO_PIN 4
#define SW0_GPIO_NAME CONFIG_GPIO_QMSI_1_NAME
/* Push button switch 1 */
#define SW1_GPIO_PIN 5
#define SW1_GPIO_NAME CONFIG_GPIO_QMSI_0_NAME
#if defined(CONFIG_NETWORKING_WITH_15_4_TI_CC2520)
/* GPIO numbers where the TI cc2520 chip is connected to */
#define CONFIG_CC2520_GPIO_VREG_EN 0 /* PIN ?, ATP_AON_INT0 (out) */
#define CONFIG_CC2520_GPIO_RESET 1 /* PIN ?, ATP_AON_INT1 (out) */
#define CONFIG_CC2520_GPIO_FIFO 4 /* PIN 4, GPIO4 (in) */
#define CONFIG_CC2520_GPIO_FIFOP 5 /* PIN 5, GPIO5 (in) */
#define CONFIG_CC2520_GPIO_CCA 6 /* PIN 6, GPIO6 (in) */
#define CONFIG_CC2520_GPIO_SFD 29 /* PIN 33, GPIO29 (in) */
enum cc2520_gpio_index {
/* If all the GPIOs can be served by same driver, then you
* can set the values to be the same. The first enum should
* always have a value of 0.
*/
CC2520_GPIO_IDX_RESET = 0,
CC2520_GPIO_IDX_VREG_EN = 0,
CC2520_GPIO_IDX_SFD = 1,
CC2520_GPIO_IDX_CCA = 1,
CC2520_GPIO_IDX_FIFOP = 1,
CC2520_GPIO_IDX_FIFO = 1,
CC2520_GPIO_IDX_LAST_ENTRY
};
#endif /* CONFIG_NETWORKING_WITH_15_4_TI_CC2520 */
#if defined(CONFIG_USB)
/* GPIO driver name */
#define USB_GPIO_DRV_NAME CONFIG_GPIO_QMSI_0_NAME
/* GPIO pin for enabling VBUS */
#define USB_VUSB_EN_GPIO 28
#endif
#endif /* __BOARD_H__ */