55 lines
1.2 KiB
ReStructuredText
55 lines
1.2 KiB
ReStructuredText
.. _fade-led-sample:
|
|
|
|
PWM: Fade LED
|
|
#############
|
|
|
|
Overview
|
|
********
|
|
|
|
This is a sample app which fades a LED using PWM.
|
|
|
|
The LED will start from dark and increases its
|
|
brightness gradually for 10 seconds. Then, the
|
|
brightness reduces gradually for 10 seconds and
|
|
finally the LED becomes dark again. The LED will
|
|
repeat this cycle for ever.
|
|
|
|
Wiring
|
|
******
|
|
|
|
Nucleo_F401RE and Nucleo_L476RG
|
|
===============================
|
|
Connect PWM2(PA0) to LED
|
|
|
|
Nucleo_F103RB
|
|
=============
|
|
Connect PWM1(PA8) to LED
|
|
|
|
Hexiwear K64
|
|
============
|
|
No special board setup is necessary because there is an on-board RGB LED
|
|
connected to the K64 PWM.
|
|
|
|
nrf52840_pca10056
|
|
=================
|
|
No special board setup is necessary because there is an on-board LED connected.
|
|
|
|
Arduino 101 and Quark D2000 CRB
|
|
===============================
|
|
You will need to connect the LED to ground and PWM0 via
|
|
the shield. You may need a current limiting resistor. See
|
|
your LED datasheet.
|
|
|
|
|
|
Building and Running
|
|
********************
|
|
|
|
This sample can be built for multiple boards, in this example we will build it
|
|
for the arduino_101 board:
|
|
|
|
.. zephyr-app-commands::
|
|
:zephyr-app: samples/basic/fade_led
|
|
:board: nrf52840_pca10056
|
|
:goals: build flash
|
|
:compact:
|