.. _lsm6dso_i2c_on_i3c:
LSM6DSO: IMU Sensor Monitor (I2C on I3C bus)
############################################
Overview
********
This sample sets the date rate of LSM6DSO accelerometer and gyroscope to
12.5Hz and enables a trigger on data ready. It displays on the console
the values for accelerometer and gyroscope.
Requirements
************
This sample uses the LSM6DSO sensor controlled using the I2C interface
exposed by the I3C controller. It has been tested using the LSM6DSO on
the evaluation board STEVAL-MKI196V1 connected to the I3C header
on :ref:`mimxrt685_evk`.
References
**********
- LSM6DSO https://www.st.com/en/mems-and-sensors/lsm6dso.html
Building and Running
********************
This project outputs sensor data to the console. It requires an LSM6DSO
sensor (for example, the one on evaluation board STEVAL-MKI196V1).
Building on mimxrt685_evk board
====================================
.. zephyr-app-commands::
:zephyr-app: samples/sensor/lsm6dso_i2c_on_i3c
:host-os: unix
:board: mimxrt685_evk
:goals: build
:compact:
Board Preparations
==================
mimxrt685_evk
------------------
On the board :ref:`mimxrt685_evk`, the I3C pins are exposed on the J18
header, where:
* SCL is on pin 1
* SDA is on pin 2
* Internal pull-up is on pin 3 (which is connected to pin 2 already)
* Ground is on pin4
LSM6DSO
^^^^^^^
A LSM6DSO sensor needs to be connected to this header. For example,
the evaluation board STEVAL-MKI196V1 can be used. This needs to be
prepared so that the LSM6DSO sensor has address 0x6B (i.e. 0xD6,
left-shifed).
Sample Output
=============
.. code-block:: console
Testing LSM6DSO sensor in trigger mode.
accel x:-0.650847 ms/2 y:-5.300102 ms/2 z:-8.163114 ms/2
gyro x:-0.167835 dps y:-0.063377 dps z:0.002367 dps
trig_cnt:1
accel x:0.341575 ms/2 y:5.209773 ms/2 z:-7.938787 ms/2
gyro x:-0.034284 dps y:-0.004428 dps z:-0.003512 dps
trig_cnt:2
<repeats endlessly>
8dc3f85622