zephyr

History

Torsten Rasmussen 407b49b35c cmake: use find_package to locate Zephyr Using find_package to locate Zephyr. Old behavior was to use $ENV{ZEPHYR_BASE} for inclusion of boiler plate code. Whenever an automatic run of CMake happend by the build system / IDE then it was required that ZEPHYR_BASE was defined. Using ZEPHYR_BASE only to locate the Zephyr package allows CMake to cache the base variable and thus allowing subsequent invocation even if ZEPHYR_BASE is not set in the environment. It also removes the risk of strange build results if a user switchs between different Zephyr based project folders and forgetting to reset ZEPHYR_BASE before running ninja / make. Signed-off-by: Torsten Rasmussen <Torsten.Rasmussen@nordicsemi.no>		2020-03-27 16:23:46 +01:00
..
src	…
CMakeLists.txt	…
README.txt	…
prj.conf	…
testcase.yaml	…

README.txt

Title: test_aes_ccm

Description:

This test verifies that the TinyCrypt AES APIs operate as expected.

--------------------------------------------------------------------------------
Building and Running Project:

This project outputs to the console.  It can be built and executed
on QEMU as follows:

    make run

--------------------------------------------------------------------------------

Troubleshooting:

Problems caused by out-dated project information can be addressed by
issuing one of the following commands then rebuilding the project:

    make clean          # discard results of previous builds
                        # but keep existing configuration info
or
    make pristine       # discard results of previous builds
                        # and restore pre-defined configuration info

--------------------------------------------------------------------------------

Sample Output:
tc_start() - Performing CCM tests:
Performing CCM test #1 (RFC 3610 test vector #1):
===================================================================
PASS - do_test.
Performing CCM test #2 (RFC 3610 test vector #2):
===================================================================
PASS - do_test.
Performing CCM test #3 (RFC 3610 test vector #3):
===================================================================
PASS - do_test.
Performing CCM test #4 (RFC 3610 test vector #7):
===================================================================
PASS - do_test.
Performing CCM test #5 (RFC 3610 test vector #8):
===================================================================
PASS - do_test.
Performing CCM test #6 (RFC 3610 test vector #9):
===================================================================
PASS - do_test.
Performing CCM test #7 (no associated data):
===================================================================
PASS - test_ccm_vector_7.
Performing CCM test #8 (no payload data):
===================================================================
PASS - test_ccm_vector_8.
All CCM tests succeeded!
===================================================================
PASS - main.
===================================================================
PROJECT EXECUTION SUCCESSFUL