zephyr/drivers/can/can_mcp2515.h

160 lines
4.7 KiB
C

/*
* Copyright (c) 2018 Karsten Koenig
*
* SPDX-License-Identifier: Apache-2.0
*
*/
#ifndef _MCP2515_H_
#define _MCP2515_H_
#include <zephyr/drivers/gpio.h>
#include <zephyr/drivers/can.h>
#define MCP2515_RX_CNT 2
/* Reduce the number of Tx buffers to 1 in order to avoid priority inversion. */
#define MCP2515_TX_CNT 1
#define MCP2515_FRAME_LEN 13
struct mcp2515_tx_cb {
struct k_sem sem;
can_tx_callback_t cb;
void *cb_arg;
};
struct mcp2515_data {
/* interrupt data */
struct gpio_callback int_gpio_cb;
struct k_thread int_thread;
k_thread_stack_t *int_thread_stack;
struct k_sem int_sem;
/* tx data */
struct k_sem tx_sem;
struct mcp2515_tx_cb tx_cb[MCP2515_TX_CNT];
uint8_t tx_busy_map;
/* filter data */
uint32_t filter_usage;
can_rx_callback_t rx_cb[CONFIG_CAN_MAX_FILTER];
void *cb_arg[CONFIG_CAN_MAX_FILTER];
struct can_filter filter[CONFIG_CAN_MAX_FILTER];
can_state_change_callback_t state_change_cb;
void *state_change_cb_data;
/* general data */
struct k_mutex mutex;
enum can_state old_state;
uint8_t sjw;
};
struct mcp2515_config {
/* spi configuration */
struct spi_dt_spec bus;
/* interrupt configuration */
struct gpio_dt_spec int_gpio;
size_t int_thread_stack_size;
int int_thread_priority;
/* CAN timing */
uint8_t tq_sjw;
uint8_t tq_prop;
uint8_t tq_bs1;
uint8_t tq_bs2;
uint32_t bus_speed;
uint32_t osc_freq;
uint16_t sample_point;
/* CAN transceiver */
const struct device *phy;
uint32_t max_bitrate;
};
/*
* Startup time of 128 OSC1 clock cycles at 1MHz (minimum clock in frequency)
* see MCP2515 datasheet section 8.1 Oscillator Start-up Timer
*/
#define MCP2515_OSC_STARTUP_US 128U
/* MCP2515 Opcodes */
#define MCP2515_OPCODE_WRITE 0x02
#define MCP2515_OPCODE_READ 0x03
#define MCP2515_OPCODE_BIT_MODIFY 0x05
#define MCP2515_OPCODE_LOAD_TX_BUFFER 0x40
#define MCP2515_OPCODE_RTS 0x80
#define MCP2515_OPCODE_READ_RX_BUFFER 0x90
#define MCP2515_OPCODE_READ_STATUS 0xA0
#define MCP2515_OPCODE_RESET 0xC0
/* MCP2515 Registers */
#define MCP2515_ADDR_CANSTAT 0x0E
#define MCP2515_ADDR_CANCTRL 0x0F
#define MCP2515_ADDR_TEC 0x1C
#define MCP2515_ADDR_REC 0x1D
#define MCP2515_ADDR_CNF3 0x28
#define MCP2515_ADDR_CNF2 0x29
#define MCP2515_ADDR_CNF1 0x2A
#define MCP2515_ADDR_CANINTE 0x2B
#define MCP2515_ADDR_CANINTF 0x2C
#define MCP2515_ADDR_EFLG 0x2D
#define MCP2515_ADDR_TXB0CTRL 0x30
#define MCP2515_ADDR_TXB1CTRL 0x40
#define MCP2515_ADDR_TXB2CTRL 0x50
#define MCP2515_ADDR_RXB0CTRL 0x60
#define MCP2515_ADDR_RXB1CTRL 0x70
#define MCP2515_ADDR_OFFSET_FRAME2FRAME 0x10
#define MCP2515_ADDR_OFFSET_CTRL2FRAME 0x01
/* MCP2515 Operation Modes */
#define MCP2515_MODE_NORMAL 0x00
#define MCP2515_MODE_LOOPBACK 0x02
#define MCP2515_MODE_SILENT 0x03
#define MCP2515_MODE_CONFIGURATION 0x04
/* MCP2515_FRAME_OFFSET */
#define MCP2515_FRAME_OFFSET_SIDH 0
#define MCP2515_FRAME_OFFSET_SIDL 1
#define MCP2515_FRAME_OFFSET_EID8 2
#define MCP2515_FRAME_OFFSET_EID0 3
#define MCP2515_FRAME_OFFSET_DLC 4
#define MCP2515_FRAME_OFFSET_D0 5
/* MCP2515_CANINTF */
#define MCP2515_CANINTF_RX0IF BIT(0)
#define MCP2515_CANINTF_RX1IF BIT(1)
#define MCP2515_CANINTF_TX0IF BIT(2)
#define MCP2515_CANINTF_TX1IF BIT(3)
#define MCP2515_CANINTF_TX2IF BIT(4)
#define MCP2515_CANINTF_ERRIF BIT(5)
#define MCP2515_CANINTF_WAKIF BIT(6)
#define MCP2515_CANINTF_MERRF BIT(7)
#define MCP2515_INTE_RX0IE BIT(0)
#define MCP2515_INTE_RX1IE BIT(1)
#define MCP2515_INTE_TX0IE BIT(2)
#define MCP2515_INTE_TX1IE BIT(3)
#define MCP2515_INTE_TX2IE BIT(4)
#define MCP2515_INTE_ERRIE BIT(5)
#define MCP2515_INTE_WAKIE BIT(6)
#define MCP2515_INTE_MERRE BIT(7)
#define MCP2515_EFLG_EWARN BIT(0)
#define MCP2515_EFLG_RXWAR BIT(1)
#define MCP2515_EFLG_TXWAR BIT(2)
#define MCP2515_EFLG_RXEP BIT(3)
#define MCP2515_EFLG_TXEP BIT(4)
#define MCP2515_EFLG_TXBO BIT(5)
#define MCP2515_EFLG_RX0OVR BIT(6)
#define MCP2515_EFLG_RX1OVR BIT(7)
#define MCP2515_TXCTRL_TXREQ BIT(3)
#define MCP2515_CANSTAT_MODE_POS 5
#define MCP2515_CANSTAT_MODE_MASK (0x07 << MCP2515_CANSTAT_MODE_POS)
#define MCP2515_CANCTRL_MODE_POS 5
#define MCP2515_CANCTRL_MODE_MASK (0x07 << MCP2515_CANCTRL_MODE_POS)
#endif /*_MCP2515_H_*/