53 lines
1.3 KiB
Plaintext
53 lines
1.3 KiB
Plaintext
CONFIG_ARM=y
|
|
CONFIG_BOARD_NUCLEO_F103RB=y
|
|
CONFIG_SOC_FAMILY_STM32=y
|
|
CONFIG_SOC_SERIES_STM32F1X=y
|
|
CONFIG_SOC_STM32F103XB=y
|
|
CONFIG_CORTEX_M_SYSTICK=y
|
|
# 72MHz system clock
|
|
CONFIG_SYS_CLOCK_HW_CYCLES_PER_SEC=72000000
|
|
|
|
# enable uart driver
|
|
CONFIG_SERIAL=y
|
|
CONFIG_UART_STM32=y
|
|
# enable USART2 - passthrough to STLINK v2 connector
|
|
CONFIG_UART_STM32_PORT_2=y
|
|
# enable console on this port by default
|
|
CONFIG_CONSOLE=y
|
|
CONFIG_UART_CONSOLE=y
|
|
|
|
# enable pinmux
|
|
CONFIG_PINMUX=y
|
|
CONFIG_PINMUX_STM32=y
|
|
|
|
# enable GPIO ports A, B, C
|
|
CONFIG_GPIO=y
|
|
CONFIG_GPIO_STM32=y
|
|
CONFIG_GPIO_STM32_PORTA=y
|
|
CONFIG_GPIO_STM32_PORTB=y
|
|
CONFIG_GPIO_STM32_PORTC=y
|
|
|
|
# clock configuration
|
|
CONFIG_CLOCK_CONTROL=y
|
|
# Clock configuration for Cube Clock control driver
|
|
CONFIG_CLOCK_STM32_HSE_CLOCK=8000000
|
|
CONFIG_CLOCK_STM32_SYSCLK_SRC_PLL=y
|
|
# use HSE as PLL input
|
|
CONFIG_CLOCK_STM32_PLL_SRC_HSE=y
|
|
# however, the board does not have an external oscillator, so just use
|
|
# the 8MHz clock signal coming from integrated STLink
|
|
CONFIG_CLOCK_STM32_HSE_BYPASS=y
|
|
# produce 72MHz clock at PLL output
|
|
CONFIG_CLOCK_STM32_PLL_XTPRE=n
|
|
CONFIG_CLOCK_STM32_PLL_MULTIPLIER=9
|
|
CONFIG_CLOCK_STM32_AHB_PRESCALER=1
|
|
# APB1 clock must not to exceed 36MHz limit
|
|
CONFIG_CLOCK_STM32_APB1_PRESCALER=2
|
|
CONFIG_CLOCK_STM32_APB2_PRESCALER=1
|
|
|
|
|
|
#enable pwm
|
|
CONFIG_PWM=y
|
|
CONFIG_PWM_STM32=y
|
|
CONFIG_PWM_STM32_1=y
|