37 lines
1.1 KiB
Plaintext
37 lines
1.1 KiB
Plaintext
CONFIG_ARM=y
|
|
CONFIG_BOARD_NUCLEO_F411RE=y
|
|
CONFIG_SOC_SERIES_STM32F4X=y
|
|
CONFIG_SOC_STM32F411XE=y
|
|
# 96MHz system clock (highest value to get a precise USB clock)
|
|
CONFIG_SYS_CLOCK_HW_CYCLES_PER_SEC=96000000
|
|
CONFIG_SYS_CLOCK_TICKS_PER_SEC=1000
|
|
|
|
# enable USART2 - passthrough to STLINK v2 connector
|
|
CONFIG_UART_STM32_PORT_2=y
|
|
CONFIG_UART_STM32_PORT_2_BAUD_RATE=115200
|
|
# enable console on this port by default
|
|
CONFIG_UART_CONSOLE_ON_DEV_NAME="UART_2"
|
|
|
|
# enable pinmux
|
|
CONFIG_PINMUX=y
|
|
|
|
# enable GPIO ports A, B, C
|
|
CONFIG_GPIO=y
|
|
|
|
# clock configuration
|
|
CONFIG_CLOCK_CONTROL=y
|
|
CONFIG_CLOCK_STM32F4X_SYSCLK_SRC_PLL=y
|
|
# use HSE as PLL input
|
|
CONFIG_CLOCK_STM32F4X_PLL_SRC_HSE=y
|
|
# however, the board does not have an external oscillator, so just use
|
|
# the 8MHz clock signal coming from integrated STLink
|
|
CONFIG_CLOCK_STM32F4X_HSE_BYPASS=y
|
|
# produce 96MHz clock at PLL output
|
|
CONFIG_CLOCK_STM32F4X_PLLM_DIV_FACTOR=8
|
|
CONFIG_CLOCK_STM32F4X_PLLN_MULTIPLIER=384
|
|
CONFIG_CLOCK_STM32F4X_PLLP_DIV_FACTOR=4
|
|
CONFIG_CLOCK_STM32F4X_PLLQ_DIV_FACTOR=8
|
|
CONFIG_CLOCK_STM32F4X_AHB_PRESCALER=0
|
|
CONFIG_CLOCK_STM32F4X_APB1_PRESCALER=2
|
|
CONFIG_CLOCK_STM32F4X_APB2_PRESCALER=0
|