.. _ArgonKey_Sensors:
ArgonKey Board Sensors
######################
Overview
********
This sample provides an example of how to read sensor data
from the ArgonKey board. The result is displayed on the console.
It makes use of both the trigger and poll methods.
Requirements
************
This sample just requires the ArgonKey board. The board can be powered
in either one of the following two ways:
- mezzanine mode, plugging the ArgonKey to HiKey board thru its 96Board
low-speed connector
- standalone mode, supplying 5V directly on P1 connector
The user may select or unselect the sensors from
:zephyr_file:`samples/boards/96b_argonkey/sensors/prj.conf`.
Please note that all sensor related code is conditionally compiled
using the ``#ifdef`` directive, so this sample is supposed to always
build correctly. Example:
.. code-block:: c
#ifdef CONFIG_HTS221
struct device *hum_dev = device_get_binding("HTS221");
if (!hum_dev) {
printk("Could not get pointer to %s sensor\n", "HTS221");
return;
}
#endif
References
**********
- :ref:`96b_argonkey`
Building and Running
********************
.. zephyr-app-commands::
:zephyr-app: samples/boards/96b_argonkey/sensors
:host-os: unix
:board: 96b_argonkey
:goals: run
:compact:
Sample Output
=============
A USB to TTL 1V8 serial cable may be attached to the low speed connector on
the back of the board on P3.5 (TX) and P3.7 (RX). User may use a simple
terminal emulator, such as minicom, to capture the output.
.. code-block:: console
proxy: 1 ;
distance: 0 m -- 09 cm;
temp: 30.35 C; press: 97.466259
humidity: 43.500000
accel (0.004000 -0.540000 9.757000) m/s2
gyro (0.065000 -0.029000 -0.001000) dps
magn (0.049500 0.208500 -0.544500) gauss
- (6) (trig_cnt: 1878)
<repeats endlessly every 2s>
In this example the output is generated polling the sensor every 2 seconds.
Sensor data is printed in the following order (no data is printed for
sensors that are not enabled):
#. *VL53L0x* proximity
#. *LPS22HB* baro/temp
#. *HTS221* humidity
#. *LSM6DSL* accel
#. *LSM6DSL* gyro
#. *LIS2MDL* magnetometer (attached to *LSM6DSL*)
The proximity sensor displays two lines:
- a flag (proxy) that goes on when the distance is below 10cm
- the absolute distance from the obstacle
The last line displays a counter of how many trigger interrupts
has been received. It is possible to display the sensor data
read for each trigger by enabling the **ARGONKEY_TEST_LOG** macro.
56048bb500