zephyr

History

Anas Nashif 23f81eeb42 tests/samples: fixed yaml syntax Use a map directory, avoid the list which makes parsing a bit cumbersome. Fixes #5109 Signed-off-by: Anas Nashif <anas.nashif@intel.com>		2017-12-11 14:47:08 -05:00
..
src	kbuild: Removed KBuild	2017-11-08 20:00:22 -05:00
CMakeLists.txt	Introduce cmake-based rewrite of KBuild	2017-11-08 20:00:22 -05:00
README.rst	samples: basic: Convert doc to CMake	2017-11-12 21:13:23 -05:00
prj.conf	kernel: remove dependency on CONFIG_NANO_TIMERS/TIMEOUTS	2017-01-08 18:09:52 +00:00
sample.yaml	tests/samples: fixed yaml syntax	2017-12-11 14:47:08 -05:00

README.rst

.. _blinky-sample:

Blinky Application
##################

Overview
********

The Blinky example shows how to configure GPIO pins as outputs which can also be
used to drive LEDs on the hardware usually delivered as "User LEDs" on many of
the supported boards in Zephyr.

Requirements
************

The demo assumes that an LED is connected to one of GPIO lines. The
sample code is configured to work on boards with user defined buttons and that
have defined the LED0\_* variables in :file:`board.h`.

The :file:`board.h` must define the following variables:

- LED0_GPIO_PORT
- LED0_GPIO_PIN


Building and Running
********************

This samples does not output anything to the console.  It can be built and
flashed to a board as follows:

.. zephyr-app-commands::
   :zephyr-app: samples/basic/blinky
   :board: arduino_101
   :goals: build flash
   :compact:

After flashing the image to the board, the user LED on the board should start to
blink.