Title: Bluetooth tester application
Description:
Tester application uses binary protocol to control Zephyr stack and is aimed at
automated testing. It requires two serial ports to operate.
The first serial is used by Bluetooth Testing Protocol (BTP) to drive Bluetooth
stack. BTP commands and events are received and buffered for further processing
over the same serial.
BTP specification can be found in auto-pts project repository:
https://github.com/intel/auto-pts
The auto-pts is an automation framework for PTS Bluetooth testing tool provided
by Bluetooth SIG.
--------------------------------------------------------------------------------
Supported Profiles:
GAP, GATT, SM
--------------------------------------------------------------------------------
Building and running on QEMU:
QEMU should have connection with the external host Bluetooth hardware.
The btproxy tool from BlueZ can be used to give access to a Bluetooth controller
attached to the Linux host OS:
$ sudo tools/btproxy -u
Listening on /tmp/bt-server-bredr
/tmp/bt-server-bredr option is already set in Makefile through QEMU_EXTRA_FLAGS.
To build tester application for QEMU use BOARD=qemu_cortex_m3 and
CONF_FILE=qemu.conf. After this qemu can be started through the "run"
build target.
Note: Target board have to support enough UARTs for BTP and controller.
We recommend using qemu_cortex_m3.
'bt-stack-tester' UNIX socket (previously set in Makefile) can be used for now
to control tester application.
--------------------------------------------------------------------------------
Building and running on Arduino 101:
Arduino 101 is equipped with Nordic nRF51 Bluetooth LE controller.
Please refer to the Zephyr Project docs [1] to see how to build and flash the
controller with the HCI Bluetooth LE firmware.
Next, build and flash tester application by employing the "flash" build
target.
While running tester application on Arduino 101, serial converter, typically
UART <-> USB is required by BTP to operate. Connect Arduino 101 Tx and Rx lines
(0 and 1 ports on Arduino 101 board) through the UART converter to the host
USB port.
Use serial client, e.g. PUTTY to communicate over the serial port
(typically /dev/ttyUSBx) with the tester using BTP.
[1] https://www.zephyrproject.org/doc/boards/x86/arduino_101/doc/board.html#flashing-the-bluetooth-core
3b53e69249