129 lines
3.2 KiB
C
129 lines
3.2 KiB
C
/*
|
|
* Copyright (c) 2019-2020 Cobham Gaisler AB
|
|
*
|
|
* SPDX-License-Identifier: Apache-2.0
|
|
*/
|
|
|
|
/*
|
|
* This driver uses two independent GPTIMER subtimers in the following way:
|
|
* - subtimer 0 generates periodic interrupts and the ISR announces ticks.
|
|
* - subtimer 1 is used as up-counter.
|
|
*/
|
|
|
|
#define DT_DRV_COMPAT gaisler_gptimer
|
|
|
|
#include <drivers/timer/system_timer.h>
|
|
#include <sys_clock.h>
|
|
|
|
/* GPTIMER subtimer increments each microsecond. */
|
|
#define PRESCALER (CONFIG_SYS_CLOCK_HW_CYCLES_PER_SEC / 1000000)
|
|
|
|
/* GPTIMER Timer instance */
|
|
struct gptimer_timer_regs {
|
|
uint32_t counter;
|
|
uint32_t reload;
|
|
uint32_t ctrl;
|
|
uint32_t latch;
|
|
};
|
|
|
|
/* A GPTIMER can have maximum of 7 subtimers. */
|
|
#define GPTIMER_MAX_SUBTIMERS 7
|
|
|
|
/* GPTIMER common registers */
|
|
struct gptimer_regs {
|
|
uint32_t scaler_value;
|
|
uint32_t scaler_reload;
|
|
uint32_t cfg;
|
|
uint32_t latch_cfg;
|
|
struct gptimer_timer_regs timer[GPTIMER_MAX_SUBTIMERS];
|
|
};
|
|
|
|
#define GPTIMER_CTRL_WN (1 << 7)
|
|
#define GPTIMER_CTRL_IP (1 << 4)
|
|
#define GPTIMER_CTRL_IE (1 << 3)
|
|
#define GPTIMER_CTRL_LD (1 << 2)
|
|
#define GPTIMER_CTRL_RS (1 << 1)
|
|
#define GPTIMER_CTRL_EN (1 << 0)
|
|
#define GPTIMER_CFG_EL (1 << 11)
|
|
#define GPTIMER_CFG_DF (1 << 9)
|
|
#define GPTIMER_CFG_SI (1 << 8)
|
|
#define GPTIMER_CFG_IRQ (0x1f << 3)
|
|
#define GPTIMER_CFG_TIMERS (7 << 0)
|
|
|
|
static volatile struct gptimer_regs *get_regs(void)
|
|
{
|
|
return (struct gptimer_regs *) DT_INST_REG_ADDR(0);
|
|
}
|
|
|
|
static int get_timer_irq(void)
|
|
{
|
|
return DT_INST_IRQN(0);
|
|
}
|
|
|
|
static uint32_t gptimer_ctrl_clear_ip;
|
|
|
|
static void timer_isr(const void *unused)
|
|
{
|
|
ARG_UNUSED(unused);
|
|
volatile struct gptimer_regs *regs = get_regs();
|
|
volatile struct gptimer_timer_regs *tmr = ®s->timer[0];
|
|
uint32_t ctrl;
|
|
|
|
ctrl = tmr->ctrl;
|
|
if ((ctrl & GPTIMER_CTRL_IP) == 0) {
|
|
return; /* interrupt not for us */
|
|
}
|
|
|
|
/* Clear pending */
|
|
tmr->ctrl = GPTIMER_CTRL_IE | GPTIMER_CTRL_RS |
|
|
GPTIMER_CTRL_EN | gptimer_ctrl_clear_ip;
|
|
|
|
z_clock_announce(1);
|
|
}
|
|
|
|
uint32_t z_clock_elapsed(void)
|
|
{
|
|
return 0;
|
|
}
|
|
|
|
uint32_t z_timer_cycle_get_32(void)
|
|
{
|
|
volatile struct gptimer_regs *regs = get_regs();
|
|
volatile struct gptimer_timer_regs *tmr = ®s->timer[1];
|
|
uint32_t counter = tmr->counter;
|
|
|
|
return (0 - counter) * PRESCALER;
|
|
}
|
|
|
|
static void init_downcounter(volatile struct gptimer_timer_regs *tmr)
|
|
{
|
|
tmr->reload = 0xFFFFFFFF;
|
|
tmr->ctrl = GPTIMER_CTRL_LD | GPTIMER_CTRL_RS | GPTIMER_CTRL_EN;
|
|
}
|
|
|
|
int z_clock_driver_init(const struct device *device)
|
|
{
|
|
const int timer_interrupt = get_timer_irq();
|
|
volatile struct gptimer_regs *regs = get_regs();
|
|
volatile struct gptimer_timer_regs *tmr = ®s->timer[0];
|
|
|
|
init_downcounter(®s->timer[1]);
|
|
|
|
/* Stop timer and probe how CTRL_IP is cleared (write 1 or 0). */
|
|
tmr->ctrl = GPTIMER_CTRL_IP;
|
|
if ((tmr->ctrl & GPTIMER_CTRL_IP) == 0) {
|
|
/* IP bit is cleared by setting it to 1. */
|
|
gptimer_ctrl_clear_ip = GPTIMER_CTRL_IP;
|
|
}
|
|
|
|
/* Configure timer scaler for 1 MHz subtimer tick */
|
|
regs->scaler_reload = PRESCALER - 1;
|
|
tmr->reload = 1000000U / CONFIG_SYS_CLOCK_TICKS_PER_SEC - 1;
|
|
tmr->ctrl = GPTIMER_CTRL_IE | GPTIMER_CTRL_LD | GPTIMER_CTRL_RS |
|
|
GPTIMER_CTRL_EN;
|
|
|
|
irq_connect_dynamic(timer_interrupt, 0, timer_isr, NULL, 0);
|
|
irq_enable(timer_interrupt);
|
|
return 0;
|
|
}
|