zephyr/tests/kernel/stackprot
Inaky Perez-Gonzalez 6db4a991b2 tests: tag with 'ignore_faults' testcases that provoke faults
This way we can monitor testcases for faults that should not be there;
however, in the case of these, a fault message is expected and shall
be ignored.

Change-Id: I63736723026c381c9fee7f24a751ceafc12f2a40
Signed-off-by: Inaky Perez-Gonzalez <inaky.perez-gonzalez@intel.com>
2017-03-24 21:51:16 +00:00
..
src license: Replace Apache boilerplate with SPDX tag 2017-01-19 03:50:58 +00:00
Makefile
README.txt build: abstract emulation and replace qemu goal with run 2017-01-10 20:20:47 +00:00
defaults.tc tests/kernel/stackprot: 'fatal fault' is not a failure 2017-01-03 19:30:54 +00:00
prj.conf
testcase.ini tests: tag with 'ignore_faults' testcases that provoke faults 2017-03-24 21:51:16 +00:00

README.txt

Title: Stack Protection Support

Description:

This test verifies that stack canaries operate as expected in the microkernel.

--------------------------------------------------------------------------------

Building and Running Project:

This microkernel project outputs to the console.  It can be built and executed
on QEMU as follows:

    make run

--------------------------------------------------------------------------------

Troubleshooting:

Problems caused by out-dated project information can be addressed by
issuing one of the following commands then rebuilding the project:

    make clean          # discard results of previous builds
                        # but keep existing configuration info
or
    make pristine       # discard results of previous builds
                        # and restore pre-defined configuration info

--------------------------------------------------------------------------------

Sample Output:
tc_start() - Test Stack Protection Canary

Starts main
Starts alternate_thread
alternate_thread: Input string is too long and stack overflowed!

***** Stack Check Fail! *****
Current thread ID = 0x00103180
Faulting segment:address = 0xdead:0xdeaddead
eax: 0xdeaddead, ebx: 0xdeaddead, ecx: 0xdeaddead, edx: 0xdeaddead
esi: 0xdeaddead, edi: 0xdeaddead, ebp: 0deaddead, esp: 0xdeaddead
eflags: 0xdeaddead
Fatal fault in thread 0x00103180! Aborting.
main: Stack ok
main: Stack ok
main: Stack ok
main: Stack ok
main: Stack ok
main: Stack ok
===================================================================
PASS - main.
===================================================================
PROJECT EXECUTION SUCCESSFUL