.. _bluetooth_direction_finding_connectionless_tx:
Bluetooth: Direction Finding Periodic Advertising Beacon
########################################################
Overview
********
A simple application demonstrating the BLE Direction Finding CTE Broadcaster
functionality by sending Constant Tone Extension with periodic advertising PDUs.
Requirements
************
* nRF52833DK board with nRF52833 SOC
* antenna matrix for AoD (optional)
Building and Running
********************
This sample can be found under :zephyr_file:`samples/bluetooth/
direction_finding_connectionless_tx` in the Zephyr tree.
By default the application supports Angle of Arrival and Angle of Departure
mode.
To use Angle of Arrival mode only, build this application as follows:
.. zephyr-app-commands::
:zephyr-app: samples/bluetooth/direction_finding_connectionless_tx
:host-os: unix
:board: nrf52833dk_nrf52833
:gen-args: -DOVERLAY_CONFIG=overlay-aoa.conf
:goals: build flash
:compact:
See :ref:`bluetooth samples section <bluetooth-samples>` for common information
about bluetooth samples.
Antenna matrix configuration
****************************
To use this sample with Angle of Departure enabled, additional GPIOS configuration
is required to enable control of the antenna array. Example of such configuration
is provided in :zephyr_file:`samples/bluetooth/direction_finding_connectionless_tx/boards/
nrf52833dk_nrf52833.overlay`.
:zephyr_file:`samples/bluetooth/direction_finding_connectionless_tx/boards/
nrf52833dk_nrf52833.overlay` is a device tree overlay that provides information
about which GPIOS should be used by Radio peripheral to switch between antenna
patches during CTE transmission in AoD mode. At least two GPIOs must be provided
to enable antenna switching. GPIOS are used by Radio peripheral in order following
indices of :code:`dfegpio#-gpios` properties. The order is important because it
affects mapping of antenna switch patterns to GPIOS (see `Antenna patterns`_).
Antenna patterns
****************
The antenna switch pattern is a binary number where each bit is applied to
a particular antenna GPIO pin. For example, the pattern 0x3 means that antenna
GPIOs at index 0,1 will be set, and following are left unset.
This also means that, for example, when using four GPIOs, the patterns count
cannot be greater than 16 and maximum allowed value is 15.
If the number of switch-sample periods is greater than the number of stored
switch patterns, then the radio loops back first pattern.
To successfully use Direction Finding Beacon with AoD mode enabled provide
following data related with owned antenna matrix design:
* provide GPIO pins to :code:`dfegpio#-gpios` propreties in
:zephyr_file:`samples/bluetooth/direction_finding_connectionless_tx/boards/
nrf52833dk_nrf52833.overlay` file
* provide default antenna that will be used to transmit PDU :code:`dfe-pdu-ant`
property in :zephyr_file:`samples/bluetooth/direction_finding_connectionless_tx/boards/
nrf52833dk_nrf52833.overlay` file
* update antenna patterns in :cpp:var:`ant_patterns` array in :zephyr_file:`samples/
bluetooth/direction_finding_connectionless_tx/src/main.c`.
8ed26a0927