61 lines
1.6 KiB
C
61 lines
1.6 KiB
C
/*
|
|
* Copyright (c) 2016 Piotr Mienkowski
|
|
* Copyright (c) 2019-2024 Gerson Fernando Budke <nandojve@gmail.com>
|
|
* SPDX-License-Identifier: Apache-2.0
|
|
*/
|
|
|
|
/** @file
|
|
* @brief System module to support early Atmel SAM V71 MCU configuration
|
|
*/
|
|
|
|
#include <zephyr/device.h>
|
|
#include <zephyr/init.h>
|
|
#include <soc.h>
|
|
#include <zephyr/arch/cpu.h>
|
|
|
|
/**
|
|
* @brief Perform SoC configuration at boot.
|
|
*
|
|
* This should be run early during the boot process but after basic hardware
|
|
* initialization is done.
|
|
*/
|
|
void atmel_samv71_config(void)
|
|
{
|
|
if (IS_ENABLED(CONFIG_SOC_ATMEL_SAM_DISABLE_ERASE_PIN)) {
|
|
/* Disable ERASE function on PB12 pin, this is controlled
|
|
* by Bus Matrix
|
|
*/
|
|
MATRIX->CCFG_SYSIO |= CCFG_SYSIO_SYSIO12;
|
|
}
|
|
|
|
/* In Cortex-M based SoCs JTAG interface can be used to perform
|
|
* IEEE1149.1 JTAG Boundary scan only. It can not be used as a debug
|
|
* interface therefore there is no harm done by disabling the JTAG TDI
|
|
* pin by default.
|
|
*/
|
|
/* Disable TDI function on PB4 pin, this is controlled by Bus Matrix
|
|
*/
|
|
MATRIX->CCFG_SYSIO |= CCFG_SYSIO_SYSIO4;
|
|
|
|
if (IS_ENABLED(CONFIG_LOG_BACKEND_SWO)) {
|
|
/* Disable PCK3 clock used by ETM module */
|
|
PMC->PMC_SCDR = PMC_SCDR_PCK3;
|
|
while ((PMC->PMC_SCSR) & PMC_SCSR_PCK3) {
|
|
;
|
|
}
|
|
/* Select PLLA clock as PCK3 clock */
|
|
PMC->PMC_PCK[3] = PMC_MCKR_CSS_PLLA_CLK;
|
|
/* Enable PCK3 clock */
|
|
PMC->PMC_SCER = PMC_SCER_PCK3;
|
|
/* Wait for PCK3 setup to complete */
|
|
while (!((PMC->PMC_SR) & PMC_SR_PCKRDY3)) {
|
|
;
|
|
}
|
|
/* Enable TDO/TRACESWO function on PB5 pin */
|
|
MATRIX->CCFG_SYSIO &= ~CCFG_SYSIO_SYSIO5;
|
|
} else {
|
|
/* Disable TDO/TRACESWO function on PB5 pin */
|
|
MATRIX->CCFG_SYSIO |= CCFG_SYSIO_SYSIO5;
|
|
}
|
|
}
|