.. _bmm150:
BMM150 Geomagnetic Sensor
#########################
Overview
********
This sample application periodically reads magnetometer (X, Y, Z) data from
the first available device that implements SENSOR_CHAN_MAGN_* (predefined array
of device names). This sample checks the sensor in polling mode (without
interrupt trigger).
Building and Running
********************
This sample application uses an BMM150 sensor connected to an Arduino 101 board via I2C.
Sensor has multiple pins so you need to connect according to connection diagram given in
`bmm150 datasheet`_ at page 41.
There are two processor cores (x86 and ARC) on the Arduino 101. You will need to
flash both this sample's code on the ARC core (using the ``arduino101_ss`` board target),
and stub code on the x86 core (using the ``arduino_101`` board target), as shown below.
.. code-block:: console
.. zephyr-app-commands::
:zephyr-app: samples/sensors/bmm150
:board: arduino_101_sss
:goals: flash
:compact:
.. zephyr-app-commands::
:zephyr-app: tests/booting/stub
:board: arduino_101
:goals: flash
:compact:
Sample Output
=============
To check output of this sample , any serial console program can be used.
Here I am using picocom program to open output. Check which tty device it is.
In my case it is ttyUSB0
.. code-block:: console
$ sudo picocom -D /dev/ttyUSB0
.. code-block:: console
( x y z ) = ( -0.390625 0.087500 -0.390625 )
( x y z ) = ( -0.275000 0.115625 -0.275000 )
( x y z ) = ( -0.281250 0.125000 -0.281250 )
( x y z ) = ( -0.287500 0.134375 -0.287500 )
.. _bmm150 datasheet: http://www.mouser.com/ds/2/783/BST-BMM150-DS001-01-786480.pdf
23f81eeb42