20202902f2
These changes were obtained by running a script created by
Ulf Magnusson <Ulf.Magnusson@nordicsemi.no> for the following
specification:
1. Read the contents of all dts_fixup.h files in Zephyr
2. Check the left-hand side of the #define macros (i.e. the X in
#define X Y)
3. Check if that name is also the name of a Kconfig option
3.a If it is, then do nothing
3.b If it is not, then replace CONFIG_ with DT_ or add DT_ if it
has neither of these two prefixes
4. Replace the use of the changed #define in the code itself
(.c, .h, .ld)
Additionally, some tweaks had to be added to this script to catch some
of the macros used in the code in a parameterized form, e.g.:
- CONFIG_GPIO_STM32_GPIO##__SUFFIX##_BASE_ADDRESS
- CONFIG_UART_##idx##_TX_PIN
- I2C_SBCON_##_num##_BASE_ADDR
and to prevent adding DT_ prefix to the following symbols:
- FLASH_START
- FLASH_SIZE
- SRAM_START
- SRAM_SIZE
- _ROM_ADDR
- _ROM_SIZE
- _RAM_ADDR
- _RAM_SIZE
which are surprisingly also defined in some dts_fixup.h files.
Finally, some manual corrections had to be done as well:
- name##_IRQ -> DT_##name##_IRQ in uart_stm32.c
Signed-off-by: Andrzej Głąbek <andrzej.glabek@nordicsemi.no>
|
||
|---|---|---|
| .. | ||
| CMakeLists.txt | ||
| Kconfig.defconfig.cc3220sf | ||
| Kconfig.defconfig.series | ||
| Kconfig.series | ||
| Kconfig.soc | ||
| README | ||
| dts_fixup.h | ||
| linker.ld | ||
| soc.c | ||
| soc.h | ||
README
CC3220 Info taken from: * http://www.ti.com/lit/ug/swru465/swru465.pdf Notes for CC3220SF: * Text must start at 0x800 offset in flash. The first 0x800 bytes are reserved for the flash header. * See CONFIG_TEXT_SECTION_OFFSET.