zephyr/boards/x86/minnowboard/doc/minnowboard.rst

70 lines
1.8 KiB
ReStructuredText

.. _minnowboard_board:
MinnowBoard Max
###############
Overview
********
The `MinnowBoard`_ board configuration supports the following:
* HPET
* Advanced Programmed Interrupt Controller (APIC)
* NS16550 UART
Hardware
********
Supported Features
==================
This board configuration supports the following hardware features:
+--------------+------------+-----------------------+
| Interface | Controller | Driver/Component |
+==============+============+=======================+
| HPET | on-chip | system clock |
+--------------+------------+-----------------------+
| APIC | on-chip | interrupt controller |
+--------------+------------+-----------------------+
| NS16550 | on-chip | serial port |
| UART | | |
+--------------+------------+-----------------------+
The kernel currently does not support other hardware features on this platform.
HPET System Clock Support
--------------------------
This board uses a system clock frequency of 25 MHz.
.. note::
The LOAPIC timer may be used instead of the HPET. To do so,
set SYS_CLOCK_HW_CYCLES_PER_SEC to a custom value that is tied to the host system speed.
Serial Port
-----------
This board uses a single serial communication channel
with a NS16550 serial driver that operates in polling mode.
For an interrupt-driven driver, enable the UART_INTERRUPT_DRIVEN kernel configuration option.
Known Problems or Limitations
-----------------------------
The following platform features are unsupported:
* Isolated Memory Regions
* Serial port in Direct Memory Access (DMA) mode
* Serial Peripheral Interface (SPI) flash
* General-Purpose Input/Output (GPIO)
* Inter-Integrated Circuit (I2C)
* Ethernet
* Supervisor Mode Execution Protection (SMEP)
.. _MinnowBoard: https://minnowboard.org/