zephyr/samples/grove/lcd
Ulf Magnusson f346c7aeaf samples: grove: Remove CONFIG_GROVE_LCD_RGB_INIT_PRIORITY assignment
This symbol was removed in commit 33118f9212 ("sensor: grove: use
global sensor init priority"), which switched over to using
CONFIG_APPLICATION_INIT_PRIORITY.

Signed-off-by: Ulf Magnusson <Ulf.Magnusson@nordicsemi.no>
2018-05-24 08:05:42 -04:00
..
src
CMakeLists.txt
README.rst
prj.conf samples: grove: Remove CONFIG_GROVE_LCD_RGB_INIT_PRIORITY assignment 2018-05-24 08:05:42 -04:00
sample.yaml

README.rst

.. _grove-lcd-sample:

Grove LCD
#########

Overview
********

This sample displays an incrementing counter through the Grove LCD, with
changing backlight.

Requirements
************

To use this sample, the following hardware is required:

* Arduino 101 or Quark D2000 Devboard
* `Grove LCD module`_
* `Grove Base Shield`_ [Optional]

Wiring
******

You will need to connect the Grove LCD via the Grove shield onto a board that
supports Arduino shields.

On some boards you will need to use 2 pull-up resistors (10k Ohm) between the
SCL/SDA lines and 3.3V.

.. note::

   The I2C lines on Quark SE Sensor Subsystem does not have internal pull-up, so
   external one is required.

Take note that even though SDA and SCL are connected to a 3.3V power source, the
Grove LCD VDD line needs to be connected to the 5V power line, otherwise
characters will not be displayed on the LCD (3.3V is enough to power just the
backlight).


Building and Running
********************

This sample should work on any board that has I2C enabled and has an Arduino
shield interface. For example, it can be run on the Quark D2000 DevBoard as
described below:

.. zephyr-app-commands::
   :zephyr-app: samples/grove/lcd
   :board: quark_d2000_crb
   :goals: flash
   :compact:

.. _Grove Base Shield: http://wiki.seeedstudio.com/wiki/Grove_-_Base_Shield
.. _Grove LCD module: http://wiki.seeed.cc/Grove-LCD_RGB_Backlight/