zephyr/soc/nxp/imxrt/imxrt10xx/pinctrl_soc.h

101 lines
4.1 KiB
C

/*
* Copyright (c) 2022, NXP
*
* SPDX-License-Identifier: Apache-2.0
*/
#ifndef ZEPHYR_SOC_ARM_NXP_IMX_RT_PINCTRL_RT10XX_H_
#define ZEPHYR_SOC_ARM_NXP_IMX_RT_PINCTRL_RT10XX_H_
#include <zephyr/devicetree.h>
#include <zephyr/types.h>
#include "fsl_common.h"
#ifdef __cplusplus
extern "C" {
#endif
#define MCUX_IMX_INPUT_SCHMITT_ENABLE_SHIFT IOMUXC_SW_PAD_CTL_PAD_HYS_SHIFT
#define MCUX_IMX_BIAS_PULL_DOWN_SHIFT IOMUXC_SW_PAD_CTL_PAD_PUS_SHIFT
#define MCUX_IMX_BIAS_PULL_UP_SHIFT IOMUXC_SW_PAD_CTL_PAD_PUS_SHIFT
#define MCUX_IMX_BIAS_BUS_HOLD_SHIFT IOMUXC_SW_PAD_CTL_PAD_PUE_SHIFT
#define MCUX_IMX_PULL_ENABLE_SHIFT IOMUXC_SW_PAD_CTL_PAD_PKE_SHIFT
#define MCUX_IMX_DRIVE_OPEN_DRAIN_SHIFT IOMUXC_SW_PAD_CTL_PAD_ODE_SHIFT
#define MCUX_IMX_SPEED_SHIFT IOMUXC_SW_PAD_CTL_PAD_SPEED_SHIFT
#define MCUX_IMX_DRIVE_STRENGTH_SHIFT IOMUXC_SW_PAD_CTL_PAD_DSE_SHIFT
#define MCUX_IMX_SLEW_RATE_SHIFT IOMUXC_SW_PAD_CTL_PAD_SRE_SHIFT
#define MCUX_IMX_INPUT_ENABLE_SHIFT 31 /* Shift to a bit not used by IOMUXC_SW_PAD_CTL */
#define MCUX_IMX_INPUT_ENABLE(x) ((x >> MCUX_IMX_INPUT_ENABLE_SHIFT) & 0x1)
#define Z_PINCTRL_MCUX_IMX_PINCFG_INIT(node_id) \
((DT_PROP(node_id, input_schmitt_enable) << MCUX_IMX_INPUT_SCHMITT_ENABLE_SHIFT) | \
IF_ENABLED(DT_PROP(node_id, bias_pull_up), (DT_ENUM_IDX(node_id, bias_pull_up_value) \
<< MCUX_IMX_BIAS_PULL_UP_SHIFT) |) \
IF_ENABLED(DT_PROP(node_id, bias_pull_down), (DT_ENUM_IDX(node_id, bias_pull_down_value)\
<< MCUX_IMX_BIAS_PULL_DOWN_SHIFT) |) \
((DT_PROP(node_id, bias_pull_down) | DT_PROP(node_id, bias_pull_up)) \
<< MCUX_IMX_BIAS_BUS_HOLD_SHIFT) | \
((!DT_PROP(node_id, bias_disable)) << MCUX_IMX_PULL_ENABLE_SHIFT) | \
(DT_PROP(node_id, drive_open_drain) << MCUX_IMX_DRIVE_OPEN_DRAIN_SHIFT) | \
(DT_ENUM_IDX(node_id, nxp_speed) << MCUX_IMX_SPEED_SHIFT) | \
(DT_ENUM_IDX(node_id, drive_strength) << MCUX_IMX_DRIVE_STRENGTH_SHIFT) | \
(DT_ENUM_IDX(node_id, slew_rate) << MCUX_IMX_SLEW_RATE_SHIFT) | \
(DT_PROP(node_id, input_enable) << MCUX_IMX_INPUT_ENABLE_SHIFT))
/* This struct must be present. It is used by the mcux gpio driver */
struct pinctrl_soc_pinmux {
uint32_t mux_register; /* IOMUXC SW_PAD_MUX register */
uint32_t config_register; /* IOMUXC SW_PAD_CTL register */
uint32_t input_register; /* IOMUXC SELECT_INPUT DAISY register */
uint32_t gpr_register; /* IOMUXC GPR register */
uint8_t gpr_shift: 5; /* bitshift for GPR register write */
uint8_t mux_mode: 4; /* Mux value for SW_PAD_MUX register */
uint32_t input_daisy:4; /* Mux value for SELECT_INPUT_DAISY register */
uint8_t gpr_val: 1; /* value to write to GPR register */
};
struct pinctrl_soc_pin {
struct pinctrl_soc_pinmux pinmux;
uint32_t pin_ctrl_flags; /* value to write to IOMUXC_SW_PAD_CTL register */
};
typedef struct pinctrl_soc_pin pinctrl_soc_pin_t;
/* This definition must be present. It is used by the mcux gpio driver */
#define MCUX_IMX_PINMUX(node_id) \
{ \
.mux_register = DT_PROP_BY_IDX(node_id, pinmux, 0), \
.config_register = DT_PROP_BY_IDX(node_id, pinmux, 4), \
.input_register = DT_PROP_BY_IDX(node_id, pinmux, 2), \
.mux_mode = DT_PROP_BY_IDX(node_id, pinmux, 1), \
.input_daisy = DT_PROP_BY_IDX(node_id, pinmux, 3), \
IF_ENABLED(DT_PROP_HAS_IDX(node_id, gpr, 0), \
(.gpr_register = DT_PROP_BY_IDX(node_id, gpr, 0),)) \
IF_ENABLED(DT_PROP_HAS_IDX(node_id, gpr, 1), \
(.gpr_shift = DT_PROP_BY_IDX(node_id, gpr, 1),)) \
IF_ENABLED(DT_PROP_HAS_IDX(node_id, gpr, 2), \
(.gpr_val = DT_PROP_BY_IDX(node_id, gpr, 2),)) \
}
#define Z_PINCTRL_PINMUX(group_id, pin_prop, idx) \
MCUX_IMX_PINMUX(DT_PHANDLE_BY_IDX(group_id, pin_prop, idx))
#define Z_PINCTRL_STATE_PIN_INIT(group_id, pin_prop, idx) \
{ \
.pinmux = Z_PINCTRL_PINMUX(group_id, pin_prop, idx), \
.pin_ctrl_flags = Z_PINCTRL_MCUX_IMX_PINCFG_INIT(group_id), \
},
#define Z_PINCTRL_STATE_PINS_INIT(node_id, prop) \
{DT_FOREACH_CHILD_VARGS(DT_PHANDLE(node_id, prop), \
DT_FOREACH_PROP_ELEM, pinmux, Z_PINCTRL_STATE_PIN_INIT)}; \
#ifdef __cplusplus
}
#endif
#endif /* ZEPHYR_SOC_ARM_NXP_IMX_RT_PINCTRL_RT10XX_H_ */