zephyr/drivers/flash/Kconfig.simulator

98 lines
2.8 KiB
Plaintext

# Flash simulator config
# Copyright (c) 2018 Nordic Semiconductor ASA
# SPDX-License-Identifier: Apache-2.0
menuconfig FLASH_SIMULATOR
bool "Flash simulator"
default y
depends on DT_HAS_ZEPHYR_SIM_FLASH_ENABLED
select FLASH_HAS_PAGE_LAYOUT
select FLASH_HAS_DRIVER_ENABLED
help
Enable the flash simulator.
if FLASH_SIMULATOR
config FLASH_SIMULATOR_UNALIGNED_READ
bool "Allow read access to be unaligned"
default y
help
If selected, the reading operation does not check if access is aligned.
Disable this option only if you want to simulate
a specific FLASH interface that requires aligned read access.
config FLASH_SIMULATOR_EXPLICIT_ERASE
bool "Program-erase device"
select FLASH_HAS_EXPLICIT_ERASE
default y
help
Explicit erase (non-erase-on-write) Flash, which is device that requires erase
to erase-value prior to write as it only allows to change bits from erase-value
to the opposite.
config FLASH_SIMULATOR_RAMLIKE
bool
default y if !FLASH_SIMULATOR_EXPLICIT_ERASE
select FLASH_HAS_NO_EXPLICIT_ERASE
select FLASH_SIMULATOR_DOUBLE_WRITES
help
This is used for setting FLASH_HAS_NO_EXPLICIT_ERASE.
config FLASH_SIMULATOR_DOUBLE_WRITES
bool "Allow program units to be programmed more than once"
help
If selected, writing to a non-erased program unit will succeed, otherwise, it will return an error.
Keep in mind that write operations can only change value of a bit from erase-value to the
opposite.
This option does not impact FLASH_SIMULATOR_RAMLIKE.
In case when FLASH_SIMULATOR_EXPLICIT_ERASE is selected multiple writes to the same bit
but only change from erase-value to opposite will be registered.
config FLASH_SIMULATOR_SIMULATE_TIMING
bool "Hardware timing simulation"
if FLASH_SIMULATOR_SIMULATE_TIMING
config FLASH_SIMULATOR_MIN_READ_TIME_US
int "Minimum read time (µS)"
default 2
range 1 1000000
config FLASH_SIMULATOR_MIN_WRITE_TIME_US
int "Minimum write time (µS)"
default 100
range 1 1000000
config FLASH_SIMULATOR_MIN_ERASE_TIME_US
int "Minimum erase time (µS)"
default 2000
range 1 1000000
endif
config FLASH_SIMULATOR_STATS
bool "flash operations statistic"
default y
select STATS
select STATS_NAMES
help
Gather statistic measurement for flash simulator operations using the
statistic subsystem.
config FLASH_SIMULATOR_STAT_PAGE_COUNT
int "Pages under statistic"
depends on FLASH_SIMULATOR_STATS
range 1 256
default 256
help
Only up to this number of beginning pages will be tracked
while catching dedicated flash operations and thresholds.
This number is not automatic because implementation uses
UNTIL_REPEAT() macro, which is limited to take explicitly
number of iterations.
This is why it's not possible to calculate the number of pages with
preprocessor using DT properties.
endif # FLASH_SIMULATOR