zephyr/tests/arch/arm/arm_irq_vector_table
Torsten Rasmussen 1cccc8a8fe cmake: increase minimal required version to 3.20.0
Move to CMake 3.20.0.

At the Toolchain WG it was decided to move to CMake 3.20.0.

The main reason for increasing CMake version is better toolchain
support.

Better toolchain support is added in the following CMake versions:
- armclang, CMake 3.15
- Intel oneAPI, CMake 3.20
- IAR, CMake 3.15 and 3.20

Signed-off-by: Torsten Rasmussen <Torsten.Rasmussen@nordicsemi.no>
2021-08-20 09:47:34 +02:00
..
src
CMakeLists.txt cmake: increase minimal required version to 3.20.0 2021-08-20 09:47:34 +02:00
Kconfig
README.txt
prj.conf
testcase.yaml

README.txt

Title: Installation of ISRs Directly in the Vector Table (ARM Only)

Description:

Verify a project can install ISRs directly in the vector table. Only for
ARM Cortex-M targets.

---------------------------------------------------------------------------

Building and Running Project:

This project outputs to the console.  It can be built and executed on QEMU as
follows:

    make run

---------------------------------------------------------------------------

Troubleshooting:

Problems caused by out-dated project information can be addressed by
issuing one of the following commands then rebuilding the project:

    make clean          # discard results of previous builds
                        # but keep existing configuration info
or
    make pristine       # discard results of previous builds
                        # and restore pre-defined configuration info

---------------------------------------------------------------------------

Sample Output:

tc_start() - Test Cortex-M3 IRQ installed directly in vector table
isr0 ran!
isr1 ran!
isr2 ran!
PASS - main.
===================================================================
PROJECT EXECUTION SUCCESSFUL