zephyr/tests/kernel/stackprot
Inaky Perez-Gonzalez 57eb17a8ca tests/kernel/stackprot: 'fatal fault' is not a failure
By default, when a 'fatal fault' message is seen in the output of any
testcase, it is consider an inmediate fatal condition and the test
case is aborted.

However, this testcase is provoking the situation to verify the
condition is caught. This, it shall NOT be considered a fatal fault
and the default overriden to allow it to proceed.

This was done in the legacy testcases and now is moved to this
testcase, ported from legacy.

Change-Id: Icac6cf55cae2ffd9b071e9dd1f35918b7b30de5e
Signed-off-by: Inaky Perez-Gonzalez <inaky.perez-gonzalez@intel.com>
2017-01-03 19:30:54 +00:00
..
src
Makefile
README.txt
defaults.tc tests/kernel/stackprot: 'fatal fault' is not a failure 2017-01-03 19:30:54 +00:00
prj.conf
testcase.ini

README.txt

Title: Stack Protection Support

Description:

This test verifies that stack canaries operate as expected in the microkernel.

--------------------------------------------------------------------------------

Building and Running Project:

This microkernel project outputs to the console.  It can be built and executed
on QEMU as follows:

    make qemu

--------------------------------------------------------------------------------

Troubleshooting:

Problems caused by out-dated project information can be addressed by
issuing one of the following commands then rebuilding the project:

    make clean          # discard results of previous builds
                        # but keep existing configuration info
or
    make pristine       # discard results of previous builds
                        # and restore pre-defined configuration info

--------------------------------------------------------------------------------

Sample Output:
tc_start() - Test Stack Protection Canary

Starts main
Starts alternate_thread
alternate_thread: Input string is too long and stack overflowed!

***** Stack Check Fail! *****
Current thread ID = 0x00103180
Faulting segment:address = 0xdead:0xdeaddead
eax: 0xdeaddead, ebx: 0xdeaddead, ecx: 0xdeaddead, edx: 0xdeaddead
esi: 0xdeaddead, edi: 0xdeaddead, ebp: 0deaddead, esp: 0xdeaddead
eflags: 0xdeaddead
Fatal fault in thread 0x00103180! Aborting.
main: Stack ok
main: Stack ok
main: Stack ok
main: Stack ok
main: Stack ok
main: Stack ok
===================================================================
PASS - main.
===================================================================
PROJECT EXECUTION SUCCESSFUL