407b49b35c
Using find_package to locate Zephyr.
Old behavior was to use $ENV{ZEPHYR_BASE} for inclusion of boiler plate
code.
Whenever an automatic run of CMake happend by the build system / IDE
then it was required that ZEPHYR_BASE was defined.
Using ZEPHYR_BASE only to locate the Zephyr package allows CMake to
cache the base variable and thus allowing subsequent invocation even
if ZEPHYR_BASE is not set in the environment.
It also removes the risk of strange build results if a user switchs
between different Zephyr based project folders and forgetting to reset
ZEPHYR_BASE before running ninja / make.
Signed-off-by: Torsten Rasmussen <Torsten.Rasmussen@nordicsemi.no>
|
||
|---|---|---|
| .. | ||
| src | ||
| CMakeLists.txt | ||
| README | ||
| prj.conf | ||
| sample.yaml | ||
README
This is a sample app to read and write the Fujitsu MB85RC256V FRAM chip via I2C on the Quark SE Sensor Subsystem. This assumes the slave address of FRAM is 0x50, where A0, A1, and A2 are all tied to ground.