/* * Copyright (c) 2016 ARM Limited. * * SPDX-License-Identifier: Apache-2.0 * Licensed under the Apache License, Version 2.0 (the License); * you may not use this file except in compliance with the License. * You may obtain a copy of the License at * * http://www.apache.org/licenses/LICENSE-2.0 * * Unless required by applicable law or agreed to in writing, software * distributed under the License is distributed on an "AS IS" BASIS, * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. * See the License for the specific language governing permissions and * limitations under the License. */ #include #include #include #include #include "fsl_rnga.h" static int random_ksdk_init(struct device *dev) { uint32_t seed = sys_cycle_get_32(); ARG_UNUSED(dev); RNGA_Init(RNG); /* The range of seed values acquired by this method is likely * to be relatively small. The RNGA hardware uses two free * running oscillators to add entropy to the seed value, we * take care below to ensure the read rate is lower than the * rate at which the hardware can add entropy. */ RNGA_Seed(RNG, seed); RNGA_SetMode(RNG, kRNGA_ModeSleep); return 0; } uint32_t sys_rand32_get(void) { uint32_t random; uint32_t output = 0; int i; RNGA_SetMode(RNG, kRNGA_ModeNormal); /* The Reference manual states that back to back reads from * the RNGA deliver one or two bits of entropy per 32-bit * word, therefore we deliberately only use 1 bit per 32 bit * word read. */ for (i = 0; i < 32; i++) { status_t status; status = RNGA_GetRandomData(RNG, &random, sizeof(random)); __ASSERT(!status, "RNGA_GetRandomData failed"); if (status) { SYS_LOG_ERR("RNGA_GetRandomData failed with %d", status); } output <<= 1; output |= random & 1; } RNGA_SetMode(RNG, kRNGA_ModeSleep); return output; } SYS_INIT(random_ksdk_init, PRE_KERNEL_2, 99);