.. _mikroe_eth_click: Overview ******** ETH Click is an accessory board in mikroBus™ form factor. It features `ENC28J60`_, a 28-pin, 10BASE-T stand alone Ethernet Controller with an on-board MAC & PHY, 8K Bytes of Buffer RAM and SPI serial interface. More information at `Eth Click Shield website`_. Pins Assignment of the Eth Click Shield ======================================= +-----------------------+---------------------------------------------+ | Shield Connector Pin | Function | +=======================+=============================================+ | RST# | Ethernet Controller's Reset | +-----------------------+---------------------------------------------+ | CS# | SPI's Chip Select | +-----------------------+---------------------------------------------+ | SCK | SPI's ClocK | +-----------------------+---------------------------------------------+ | SDO | SPI's Slave Data Output (MISO) | +-----------------------+---------------------------------------------+ | SDI | SPI's Slave Data Input (MISO) | +-----------------------+---------------------------------------------+ | INT | Ethernet Controller's Interrupt Output | +-----------------------+---------------------------------------------+ Requirements ************ This shield can only be used with a board which provides a configuration for Mikro-BUS connectors and defines node aliases for SPI and GPIO interfaces (see :ref:`shields` for more details). Programming *********** Set ``-DSHIELD=mikroe_eth_click`` when you invoke ``west build``. For example: .. zephyr-app-commands:: :zephyr-app: samples/net/dhcp_client :board: lpcxpresso55s69 :shield: mikroe_eth_click :goals: build References ********** .. target-notes:: .. _Eth Click Shield website: https://www.mikroe.com/eth-click .. _ENC28J60: https://www.microchip.com/wwwproducts/en/en022889