CONFIG_ARM=y
CONFIG_BOARD_OLIMEXINO_STM32=y
CONFIG_SOC_FAMILY_STM32=y
CONFIG_SOC_SERIES_STM32F1X=y
CONFIG_SOC_STM32F103XB=y
CONFIG_CORTEX_M_SYSTICK=y
# 72MHz system clock
CONFIG_SYS_CLOCK_HW_CYCLES_PER_SEC=72000000

# enable uart driver
CONFIG_SERIAL=y
CONFIG_UART_STM32=y
# enable USART1
CONFIG_UART_STM32_PORT_0=y
CONFIG_UART_STM32_PORT_0_BAUD_RATE=115200
# enable console on this port by default
CONFIG_CONSOLE=y
CONFIG_UART_CONSOLE=y
CONFIG_UART_CONSOLE_ON_DEV_NAME="UART_0"


# enable pinmux
CONFIG_PINMUX=y
CONFIG_PINMUX_STM32=y

# enable GPIO ports A, B, C, D
CONFIG_GPIO=y
CONFIG_GPIO_STM32=y
CONFIG_GPIO_STM32_PORTA=y
CONFIG_GPIO_STM32_PORTB=y
CONFIG_GPIO_STM32_PORTC=y
CONFIG_GPIO_STM32_PORTD=y

# clock configuration
CONFIG_CLOCK_CONTROL=y
CONFIG_CLOCK_CONTROL_STM32F10X=y
CONFIG_CLOCK_STM32F10X_SYSCLK_SRC_PLL=y
# use HSE as PLL input
CONFIG_CLOCK_STM32F10X_PLL_SRC_HSE=y
CONFIG_CLOCK_STM32F10X_PLL_MULTIPLIER=9
CONFIG_CLOCK_STM32F10X_AHB_PRESCALER=0
# APB1 clock must not exceed 36MHz limit
CONFIG_CLOCK_STM32F10X_APB1_PRESCALER=2
CONFIG_CLOCK_STM32F10X_APB2_PRESCALER=0