# Kconfig -  Ethernet drivers configuration options

#
# Copyright (c) 2015 Intel Corporation
#
# Licensed under the Apache License, Version 2.0 (the "License");
# you may not use this file except in compliance with the License.
# You may obtain a copy of the License at
#
#     http://www.apache.org/licenses/LICENSE-2.0
#
# Unless required by applicable law or agreed to in writing, software
# distributed under the License is distributed on an "AS IS" BASIS,
# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
# See the License for the specific language governing permissions and
# limitations under the License.
#

menu "Ethernet Drivers"

config SYS_LOG_ETHERNET_LEVEL
	int
	prompt "Ethernet driver log level"
	depends on SYS_LOG && NET_L2_ETHERNET
	default 0
	range 0 4
	help
	  Sets log level for Ethernet Device Drivers.
	  Levels are:
	  0 OFF, do not write
	  1 ERROR, only write SYS_LOG_ERR
	  2 WARNING, write SYS_LOG_WRN in adition to previous level
	  3 INFO, write SYS_LOG_INF in adition to previous levels
	  4 DEBUG, write SYS_LOG_DBG in adition to previous levels

config ETH_INIT_PRIORITY
	int
	prompt "Ethernet driver init priority"
	default 80
	help
	  Ethernet device driver initialization priority.
	  Do not mess with it unless you know what you are doing.
	  Note that the priority needs to be lower than the net stack
	  so that it can start before the networking sub-system.

source "drivers/ethernet/Kconfig.enc28j60"
source "drivers/ethernet/Kconfig.mcux"
source "drivers/ethernet/Kconfig.dw"

endmenu