# Kconfig - Quark X1000 SoC configuration options # # Copyright (c) 2014-2015 Wind River Systems, Inc. # Copyright (c) 2015-2016 Intel Corporation # # Licensed under the Apache License, Version 2.0 (the "License"); # you may not use this file except in compliance with the License. # You may obtain a copy of the License at # # http://www.apache.org/licenses/LICENSE-2.0 # # Unless required by applicable law or agreed to in writing, software # distributed under the License is distributed on an "AS IS" BASIS, # WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. # See the License for the specific language governing permissions and # limitations under the License. # if SOC_QUARK_X1000 config SOC default quark_x1000 config PHYS_LOAD_ADDR default 0x00100000 config PHYS_RAM_ADDR default 0x00400000 config RAM_SIZE default 32768 config ROM_SIZE default 1024 if XIP config SYS_CLOCK_HW_CYCLES_PER_SEC default 25000000 if HPET_TIMER config CLFLUSH_DETECT def_bool y if CACHE_FLUSHING if SHARED_IRQ config SHARED_IRQ_0 def_bool y if SHARED_IRQ_0 config SHARED_IRQ_0_NAME default "SHARED_IRQ0" config SHARED_IRQ_0_IRQ default 18 config SHARED_IRQ_0_PRI default 2 endif # SHARED_IRQ_0 endif # SHARED_IRQ if PCI_LEGACY_BRIDGE config PCI_LEGACY_BRIDGE_BUS default 0 config PCI_LEGACY_BRIDGE_DEV default 31 config PCI_LEGACY_BRIDGE_VENDOR_ID default 0x8086 config PCI_LEGACY_BRIDGE_DEVICE_ID default 0x095e endif # PCI_LEGACY_BRIDGE if I2C config I2C_CLOCK_SPEED default 25 config I2C_DW def_bool y if I2C_DW config I2C_0 def_bool y if I2C_0 config I2C_0_NAME default "I2C_0" config I2C_0_DEFAULT_CFG default 0x12 config I2C_0_IRQ_PRI default 2 config I2C_0_IRQ_SHARED_NAME default SHARED_IRQ_0_NAME if SHARED_IRQ endif # I2C_0 endif # I2C_DW endif # I2C if GPIO config GPIO_SCH def_bool y if GPIO_SCH config GPIO_SCH_0 def_bool y config GPIO_SCH_1 def_bool y if GPIO_SCH_0 config GPIO_SCH_0_DEV_NAME default "GPIO_CW" endif # GPIO_SCH_0 if GPIO_SCH_1 config GPIO_SCH_1_DEV_NAME default "GPIO_RW" endif # GPIO_SCH_1 endif # GPIO_SCH config GPIO_DW def_bool y if GPIO_DW config GPIO_DW_0 def_bool y select GPIO_DW_0_IRQ_SHARED if SHARED_IRQ if GPIO_DW_0 config GPIO_DW_0_NAME default "GPIO_0" config GPIO_DW_0_IRQ_PRI default 2 config GPIO_DW_0_IRQ_SHARED_NAME default SHARED_IRQ_0_NAME if SHARED_IRQ endif # GPIO_DW_0 endif # GPIO_DW endif # GPIO if SPI config SPI_INTEL def_bool y if SPI_INTEL config SPI_CS_GPIO def_bool y config SPI_0 def_bool y if SPI_0 config SPI_0_IRQ_PRI default 2 config SPI_0_CS_GPIO_PORT default "GPIO_0" config SPI_0_CS_GPIO_PIN default 0 endif # SPI_0 config SPI_1 def_bool n if SPI_1 config SPI_1_NAME default "SPI_1" config SPI_1_IRQ_PRI default 2 config SPI_1_CS_GPIO_PORT default "GPIO_0" config SPI_1_CS_GPIO_PIN default 2 endif # SPI_1 endif # SPI_INTEL endif # SPI if UART_NS16550 config UART_NS16550_PCI def_bool y if PCI config UART_NS16550_PORT_0 def_bool y if UART_NS16550_PORT_0 config UART_NS16550_PORT_0_NAME default "UART_0" config UART_NS16550_PORT_0_IRQ_PRI default 0 config UART_NS16550_PORT_0_BAUD_RATE default 115200 config UART_NS16550_PORT_0_OPTIONS default 0 config UART_NS16550_PORT_0_PCI def_bool y if UART_NS16550_PCI endif # UART_NS16550_PORT_0 config UART_NS16550_PORT_1 def_bool y if PCI if UART_NS16550_PORT_1 config UART_NS16550_PORT_1_NAME default "UART_1" config UART_NS16550_PORT_1_IRQ_PRI default 3 config UART_NS16550_PORT_1_BAUD_RATE default 115200 config UART_NS16550_PORT_1_OPTIONS default 0 config UART_NS16550_PORT_1_PCI def_bool y if UART_NS16550_PCI endif # UART_NS16550_PORT_1 endif # UART_NS16550 if ETH_DW config ETH_DW_0 def_bool y if ETH_DW_0 config ETH_DW_0_IRQ_SHARED_NAME default SHARED_IRQ_0_NAME if SHARED_IRQ endif # ETH_DW_0 endif # ETH_DW # Pin multiplexer uses PCAL9535A, needs to be initialized after it config PINMUX_INIT_PRIORITY default 80 if PINMUX if UART_CONSOLE config UART_CONSOLE_ON_DEV_NAME default "UART_1" endif if BLUETOOTH_UART config BLUETOOTH_UART_ON_DEV_NAME default "UART_1" endif endif # SOC_QUARK_X1000