/*
 * Copyright (c) 2016 Cadence Design Systems, Inc.
 * SPDX-License-Identifier: Apache-2.0
 */

#include <zephyr/types.h>
#include <stdio.h>
#include <arch/xtensa/xtensa_api.h>
#include <kernel_arch_data.h>
#include <sys/__assert.h>
/*
 * @internal
 *
 * @brief Set an interrupt's priority
 *
 * The priority is verified if ASSERT_ON is enabled.
 *
 * The priority is verified if ASSERT_ON is enabled. The maximum number of
 * priority levels is a little complex, as there are some hardware priority
 * levels which are reserved: three for various types of exceptions, and
 * possibly one additional to support zero latency interrupts.
 *
 * Valid values are from 1 to 6. Interrupts of priority 1 are not masked when
 * interrupts are locked system-wide, so care must be taken when using them.
 * ISR installed with priority 0 interrupts cannot make kernel calls.
 *
 * @return N/A
 */

void z_irq_priority_set(unsigned int irq, unsigned int prio, u32_t flags)
{
	__ASSERT(prio < XCHAL_EXCM_LEVEL + 1,
		 "invalid priority %d! values must be less than %d\n",
		 prio, XCHAL_EXCM_LEVEL + 1);
	/* TODO: Write code to set priority if this is ever possible on
	 * Xtensa
	 */
}

#ifdef CONFIG_DYNAMIC_INTERRUPTS
#ifndef CONFIG_MULTI_LEVEL_INTERRUPTS
int z_arch_irq_connect_dynamic(unsigned int irq, unsigned int priority,
			       void (*routine)(void *parameter),
			       void *parameter, u32_t flags)
{
	ARG_UNUSED(flags);
	ARG_UNUSED(priority);

	z_isr_install(irq, routine, parameter);
	return irq;
}
#else /* !CONFIG_MULTI_LEVEL_INTERRUPTS */
int z_arch_irq_connect_dynamic(unsigned int irq, unsigned int priority,
			       void (*routine)(void *parameter),
			       void *parameter, u32_t flags)
{
	return z_soc_irq_connect_dynamic(irq, priority, routine, parameter,
					 flags);
}
#endif /* !CONFIG_MULTI_LEVEL_INTERRUPTS */
#endif /* CONFIG_DYNAMIC_INTERRUPTS */