/* lsm6dsl_spi.c - SPI routines for LSM6DSL driver */ /* * Copyright (c) 2018 STMicroelectronics * * SPDX-License-Identifier: Apache-2.0 */ #include #include #include "lsm6dsl.h" #include #ifdef DT_ST_LSM6DSL_BUS_SPI #define LSM6DSL_SPI_READ (1 << 7) #define LOG_LEVEL CONFIG_SENSOR_LOG_LEVEL LOG_MODULE_DECLARE(LSM6DSL); #if defined(DT_INST_0_ST_LSM6DSL_CS_GPIOS_CONTROLLER) static struct spi_cs_control lsm6dsl_cs_ctrl; #endif #define SPI_CS NULL static struct spi_config lsm6dsl_spi_conf = { .frequency = DT_INST_0_ST_LSM6DSL_SPI_MAX_FREQUENCY, .operation = (SPI_OP_MODE_MASTER | SPI_MODE_CPOL | SPI_MODE_CPHA | SPI_WORD_SET(8) | SPI_LINES_SINGLE), .slave = DT_INST_0_ST_LSM6DSL_BASE_ADDRESS, .cs = SPI_CS, }; static int lsm6dsl_raw_read(struct lsm6dsl_data *data, u8_t reg_addr, u8_t *value, u8_t len) { struct spi_config *spi_cfg = &lsm6dsl_spi_conf; u8_t buffer_tx[2] = { reg_addr | LSM6DSL_SPI_READ, 0 }; const struct spi_buf tx_buf = { .buf = buffer_tx, .len = 2, }; const struct spi_buf_set tx = { .buffers = &tx_buf, .count = 1 }; const struct spi_buf rx_buf[2] = { { .buf = NULL, .len = 1, }, { .buf = value, .len = len, } }; const struct spi_buf_set rx = { .buffers = rx_buf, .count = 2 }; if (len > 64) { return -EIO; } if (spi_transceive(data->comm_master, spi_cfg, &tx, &rx)) { return -EIO; } return 0; } static int lsm6dsl_raw_write(struct lsm6dsl_data *data, u8_t reg_addr, u8_t *value, u8_t len) { struct spi_config *spi_cfg = &lsm6dsl_spi_conf; u8_t buffer_tx[1] = { reg_addr & ~LSM6DSL_SPI_READ }; const struct spi_buf tx_buf[2] = { { .buf = buffer_tx, .len = 1, }, { .buf = value, .len = len, } }; const struct spi_buf_set tx = { .buffers = tx_buf, .count = 2 }; if (len > 64) { return -EIO; } if (spi_write(data->comm_master, spi_cfg, &tx)) { return -EIO; } return 0; } static int lsm6dsl_spi_read_data(struct lsm6dsl_data *data, u8_t reg_addr, u8_t *value, u8_t len) { return lsm6dsl_raw_read(data, reg_addr, value, len); } static int lsm6dsl_spi_write_data(struct lsm6dsl_data *data, u8_t reg_addr, u8_t *value, u8_t len) { return lsm6dsl_raw_write(data, reg_addr, value, len); } static int lsm6dsl_spi_read_reg(struct lsm6dsl_data *data, u8_t reg_addr, u8_t *value) { return lsm6dsl_raw_read(data, reg_addr, value, 1); } static int lsm6dsl_spi_update_reg(struct lsm6dsl_data *data, u8_t reg_addr, u8_t mask, u8_t value) { u8_t tmp_val; lsm6dsl_raw_read(data, reg_addr, &tmp_val, 1); tmp_val = (tmp_val & ~mask) | (value & mask); return lsm6dsl_raw_write(data, reg_addr, &tmp_val, 1); } static const struct lsm6dsl_transfer_function lsm6dsl_spi_transfer_fn = { .read_data = lsm6dsl_spi_read_data, .write_data = lsm6dsl_spi_write_data, .read_reg = lsm6dsl_spi_read_reg, .update_reg = lsm6dsl_spi_update_reg, }; int lsm6dsl_spi_init(struct device *dev) { struct lsm6dsl_data *data = dev->driver_data; data->hw_tf = &lsm6dsl_spi_transfer_fn; #if defined(DT_INST_0_ST_LSM6DSL_CS_GPIOS_CONTROLLER) /* handle SPI CS thru GPIO if it is the case */ lsm6dsl_cs_ctrl.gpio_dev = device_get_binding( DT_INST_0_ST_LSM6DSL_CS_GPIOS_CONTROLLER); if (!lsm6dsl_cs_ctrl.gpio_dev) { LOG_ERR("Unable to get GPIO SPI CS device"); return -ENODEV; } lsm6dsl_cs_ctrl.gpio_pin = DT_INST_0_ST_LSM6DSL_CS_GPIOS_PIN; lsm6dsl_cs_ctrl.delay = 0U; lsm6dsl_spi_conf.cs = &lsm6dsl_cs_ctrl; LOG_DBG("SPI GPIO CS configured on %s:%u", DT_INST_0_ST_LSM6DSL_CS_GPIOS_CONTROLLER, DT_INST_0_ST_LSM6DSL_CS_GPIOS_PIN); #endif return 0; } #endif /* DT_ST_LSM6DSL_BUS_SPI */