/* pinmux_quark_mcu.h - pinmux operation for generic Quark MCU boards */

/*
 * Copyright (c) 2016 Intel Corporation
 *
 * Licensed under the Apache License, Version 2.0 (the "License");
 * you may not use this file except in compliance with the License.
 * You may obtain a copy of the License at
 *
 *     http://www.apache.org/licenses/LICENSE-2.0
 *
 * Unless required by applicable law or agreed to in writing, software
 * distributed under the License is distributed on an "AS IS" BASIS,
 * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
 * See the License for the specific language governing permissions and
 * limitations under the License.
 */

#define PINMUX_PULLUP_OFFSET   0x00
#define PINMUX_SLEW_OFFSET     0x10
#define PINMUX_INPUT_OFFSET    0x20
#define PINMUX_SELECT_OFFSET   0x30

#define PINMUX_SELECT_REGISTER(base, reg_offset) \
	(base + PINMUX_SELECT_OFFSET + (reg_offset << 2))

/*
 * A little decyphering of what is going on here:
 *
 * Each pinmux register rperesents a bank of 16 pins, 2 bits per pin for a total
 * of four possible settings per pin.
 *
 * The first argument to the macro is name of the uint32_t's that is being used
 * to contain the bit patterns for all the configuration registers.  The pin
 * number divided by 16 selects the correct register bank based on the pin
 * number.
 *
 * The pin number % 16 * 2 selects the position within the register bank for the
 * bits controlling the pin.
 *
 * All but the lower two bits of the config values are masked off to ensure
 * that we don't inadvertently affect other pins in the register bank.
 */
#define PIN_CONFIG(A, _pin, _func) \
	(A[((_pin) / 16)] |= ((0x3 & (_func)) << (((_pin) % 16) * 2)))

static inline int _quark_mcu_set_mux(uint32_t base, uint32_t pin, uint8_t func)
{
	/*
	 * the registers are 32-bit wide, but each pin requires 1 bit
	 * to set the input enable bit.
	 */
	uint32_t register_offset = (pin / 32) * 4;
	/*
	 * Now figure out what is the full address for the register
	 * we are looking for.  Add the base register to the register_mask
	 */
	volatile uint32_t *mux_register = (uint32_t *)(base + register_offset);

	/*
	 * Finally grab the pin offset within the register
	 */
	uint32_t pin_offset = pin % 32;

	/*
	 * MAGIC NUMBER: 0x1 is used as the pullup is a single bit in a
	 * 32-bit register.
	 */
	(*(mux_register)) = ((*(mux_register)) & ~(0x1 << pin_offset)) |
		((func & 0x01) << pin_offset);

	return 0;
}