# XTENSA architecture configuration options

# Copyright (c) 2016 Cadence Design Systems, Inc.
# SPDX-License-Identifier: Apache-2.0

menu "XTENSA Options"
	depends on XTENSA

config ARCH
	default "xtensa"

config SIMULATOR_XTENSA
	bool "Simulator Configuration"
	help
	  Specify if the board configuration should be treated as a simulator.

config SYS_CLOCK_HW_CYCLES_PER_SEC
	prompt "Hardware clock cycles per second, 2000000 for ISS"
	default 2000000
	range 1000000 1000000000
	help
	  This option specifies hardware clock.

config XTENSA_NO_IPC
	bool "Core has no IPC support"
	select ATOMIC_OPERATIONS_C
	help
	  Uncheck this if your core does not implement "SCOMPARE1" register and "s32c1i"
	  instruction.

config XTENSA_RESET_VECTOR
	bool "Build reset vector code"
	default y
	help
	  This option controls whether the initial reset vector code is built.
	  This is always needed for the simulator. Real boards may already
	  implement this in boot ROM.

config XTENSA_USE_CORE_CRT1
	bool "Use crt1.S from core"
	default y
	help
	  SoC or boards might define their own __start by setting this setting
	  to false.

config XTENSA_ENABLE_BACKTRACE
	bool "Backtrace on panic exception"
	default y
	depends on SOC_ESP32 || SOC_FAMILY_INTEL_ADSP
	help
	  Enable this config option to print backtrace on panic exception

config XTENSA_CPU_IDLE_SPIN
	bool "Use busy loop for k_cpu_idle"
	help
	  Use a spin loop instead of WAITI for the CPU idle state.

config XTENSA_WAITI_BUG
	bool "Workaround sequence for WAITI bug on LX6"
	help
	  SOF traditionally contains this workaround on its ADSP
	  platforms which prefixes a WAITI entry with 128 NOP
	  instructions followed by an ISYNC and EXTW.

config XTENSA_SMALL_VECTOR_TABLE_ENTRY
	bool "Workaround for small vector table entries"
	help
	  This option enables a small indirection to bypass the size
	  constraint of the vector table entry and moved the default
	  handlers to the end of vector table, renaming them to
	  _Level\LVL\()VectorHelper.

config XTENSA_CACHED_REGION
	int "Cached RPO mapping"
	range 0 7
	help
	  A design trick on multi-core hardware is to map memory twice
	  so that it can be seen in both (incoherent) cached mappings
	  and a coherent "shared" area.  This specifies which 512M
	  region (0-7, as defined by the Xtensa Region Protection
	  Option) contains the "cached" mapping.

config XTENSA_UNCACHED_REGION
	int "Uncached RPO mapping"
	range 0 7
	help
	  As for XTENSA_CACHED_REGION, this specifies which 512M
	  region (0-7) contains the "uncached" mapping.

config XTENSA_CCOUNT_HZ
	int "CCOUNT cycle rate"
	default 1000000
	help
	  Rate in HZ of the Xtensa core as measured by the value of
	  the CCOUNT register.

endmenu